Answer:
Explanation:
Two moles of magnesium (Mg) and five moles of oxygen (O2) are placed in a reaction vessel. When magnesium is ignited, it reacts with oxygen. What is the limiting reactant in this experiment?
Mg + O2 → MgO (unbalanced)
first, balance the equation
2Mg +O2-------> 2MgO
two magnesium atoms react with one diatomic oxygen molecule
there is a 1:1 ratio of magnesium to oxygen atoms
but we have 2 moles of magnesium atoms and 2X5 = 10 moles of oxygen atoms
the lesser magnesium LIMITS the amount of product we can make, so it is the LIMITING REAGENT.
Molarity = (Mass/ molar mass) x (1/ volume of solution in Litres)
Mass = Molarity x molar mass x volume of solution in Litres
Molarity of Tris = 100 mM = 0.1 M
volume of Tris sol. = 100 mL = 0.1 L
molar mass of Tris = 121.1 g/mol
Hence,
mass of Tris = Molarity of Tris x molar mass ofTris x volume of Tris solution
= 0.1 M x 121.1 g/mol x 0.1 L
= 1.211 g
mass of Tris = 1.211 g
Answer:
B
Explanation:
Cause metamorphic rock is formed by heat pressure overtime
Answer:
Uses nuclear reactions to produce energy
Implodes a fuel pellet
Explanation:
Laser fusion is a method of initiating nuclear fusion reactions through heating, and compressing fuel pellets containing deuterium and tritium using high energy density laser beams. Lase fusion is also known as inertial confinement fusion and the energy produced by the process is known as Laser Inertial Fusion Energy, LIFE.
During the process of laser fusion, small pellets of deuterium-tritium (DT) isotopes mixture are fed into a blast chamber where they are compressed to high densities using a number of amplified laser beams in the chamber.
The high energy density of the beams as well as the heat produced due to compression, induces the thermonuclear explosion ignition resulting in the production of high energetic products such as charged particles, x-rays and neutrons. The energy produced is absorbed and stored as heat in a blanket that is then used in a steam thermal cycle to generate electrical power.
There are two methods of compression of the DT pellet: direct and indirect-drive laser fusions.
However, there are a number of limitations to energy production by this process. One limitation is that the process is extremely inefficient in energy energy production. Also, the heat produced by the flashtubes results innthe deformation of the laser glass.
Lowered cos the higher the ph the lower the hydrogen ions
