Here As we can see the figure that the end of the rope is pulled by some force F
Now as we can see that Piano is connected by a pulley which is passing over the pulley so effectively net force on the piano upwards will be 2F as it is connected by 2 ropes by the pulley
Now for constant velocity of the piano we will say
since velocity is constant so acceleration must be ZERO
so here we have
as we know here that
mg = 1000 N
so we will have
so here force must be 500 N
Development length: The actual length of the bent conduit. Gain: Since a conduit bends radially rather than at an angle, the total length will not match the length required for all bends. Gain is the amount of space that is saved by a curve.
Conduit benders from Klein Tools are built to function and last longer than even the highest professional standards. To ensure a favourable experience and significantly enhance the final result of your project, it is advised that you become familiar with bending concepts, procedures, and the bender's capabilities. The benders are labelled with various alignment symbols to enable the operator make the bends required to complete any job. This aids bending while executing a ground or air bend. Arrow, teardrop, star point, and angle markings are the symbols on the Klein Tools benders. On certain bender head sides, you can see these markings.
Learn more about bent conduit here:
#SPJ4