Mass wasting I think it's done
diatomic hydrogen is written as H2 (2.02 grams H2) <------- if each hydrogen atom is 1.01 grams, then two hydrogen atoms are 2.02 grams 2.0 moles H2 X 2.02 grams H2 ------------- (divide to cancel moles) = 4.04 grams/mole H2 ÷ one mole = 4.04 grams H2
Answer:
Blue: Because violet really has the most and blue is based on violet!
Explanation:
Hope this helps! Plz mark as brainliest!
Answer:
Explanation:
Nitrogen gas in nitrogen cylinder is in gaseous form only . So when gas is released , pressure decreases because moles of gas in the cylinder decreases .
Propane gas in cylinder is in liquified form . The gas is partially in gaseous and liquid form . So when gas is released outside , pressure decreases inside but due to low pressure , some liquid form is converted into gaseous form which restores the pressure of gas inside cylinder . Hence , the pressure of gas remains unchanged inside cylinder.
A is obviously out because it leads to a volume of 125.0 milliliters of the new solution and gives you a lower concentration than you were aiming for.
D is out because you are adding 75 milliliters of the stock solution, so your concentration would be too high. You only need 25.0 milometers of stock solution per 100 milliliters of the new solution.
C is also out because it leads to 50.0 milliliters stock solution per 100 milliliters of the new solution and hence the wrong concentration.
B is by default the correct answer. It also details the correct technique. First you add the stock solution (This you know from your calculations to be 25 milliliters.) then you add the water up to the volume you needed. (Because the calculations only tell you the total volume of water not what you need to add) You also add the water last so you can rinse the neck of the flask to make sure you also get all the stock solution residue into the stock solution.
I would add the final step of stirring, but B is the only answer that can be correct.
