Which of the following identifies the three main steps in the design process of an engineer?

A 360 kg/min stream of steam enters a turbine at 40 bar pressure and 100 degrees of superheat. The steam exits the turbine as a

Brrunno [24]

Answer:
skskkdkdkfkgkgkgkkgkgkgigooigigi lol
Explanation:
Oof

7 0

3 years ago

Two technicians are discussing the intake air temperature (IAT) sensor. Technician A says that the computer uses the IAT sensor

mart [117]

Both the technicians are correct.

Explanation

Intake air temperature sensor is used in engines of vehicles to monitor the temperature of air entering the engine.

They are basically made of thermistors whose electrical resistance changes according to temperature.

Depending upon the reading and accuracy of intake air temperature sensor, the power-train control module (PCM) will decide about the air and fuel mixture ratio in the engine.

The hot air in engine requires less fuel to operate the engine parts while cold air requires more fuel to operate the engine.

The ratio of air and fuel mixture should be maintained in the engine and it is done by PCM only after getting the input from IAT. So technician B is saying correct.

Also the IAT works as a backup to support the engine coolant temperature sensor by the computer.

As the IAT checks the temperature of outside air, it will help to change the coolant temperature of the engine based on the environment.

Thus technician A is also correct. So both the technicians are correct.

6 0

3 years ago

For a body moving with simple harmonic motion state the equations to represent: i) Velocity ii) Acceleration iii) Periodic Time

max2010maxim [7]

Answer with Explanation:

The general equation of simple harmonic motion is

$x(t)=Asin(\omega t+\phi)$

where,

A is the amplitude of motion

$\omega$ is the angular frequency of the motion

$\phi$ is known as initial phase

part 1)

Now by definition of velocity we have

$v=\frac{dx}{dt}\\\\\therefore v(t)=\frac{d}{dt}(Asin(\omega t+\phi )\\\\v(t)=A\omega cos(\omega t+\phi )$

part 2)

Now by definition of acceleration we have

$a=\frac{dv}{dt}\\\\\therefore a(t)=\frac{d}{dt}(A\omega cos(\omega t+\phi )\\\\a(t)=-A\omega ^{2}sin(\omega t+\phi )$

part 3)

The angular frequency is related to Time period 'T' as $T =\frac{2\pi }{\omega }$

where

$\omega$ is the angular frequency of the motion of the particle.

Part 4) The acceleration and velocities are plotted below

since the maximum value that the sin(x) and cos(x) can achieve in their respective domains equals 1 thus the maximum value of acceleration and velocity is $A\omega ^{2}$ and $A\omega$ respectively.

4 0

3 years ago

"Mass burn technology uses unprocessed municipal solid waste to generate heat which is used to produce electricity."

Flura [38]

Answer:

True

Explanation:

Mass burn technology is a type of waste-to-energy technology commonly used in the mass-burn system, where unprocessed municipal solid waste is burned in a large incinerator with a boiler, to generate heat used in the production of electricity.

6 0

3 years ago

Read 2 more answers

Determine the following parameters for the water having quality x=0.7 at 200 kPa:

ra1l [238]

Solution :

Given :

Water have quality x = 0.7 (dryness fraction) at around pressure of 200 kPa

The phase diagram is provided below.

a). The phase is a standard mixture.

b). At pressure, p = 200 kPa, T = $T_{saturated}$