All categories

3 years ago

Please helppp me with science

Physics

1 answer:

Olenka [21]3 years ago

4 0

H's result was one dead flower ... not surprising ... stuck in a dark room = no photosynthesis = no growth = death.
H loses is "control" part of his "experiment".
Q gives no idea the colour of H's flowers in expt.
H "shows" that a watered plant in sunlight with a bit of fetilizer tends to grow. He could have had a look outside at a garden to see that.

improvement by not killing the "control" plant. put it side by side with the test plant, so both get the photo stuff. Then measured fertilizer in test plant, and same water minus fert in control.

As for the colour I've no idea.

You might be interested in

You are given a copper bar of dimensions 3 cm × 5 cm × 8 cm and asked to attach leads to it in order to make a resistor. If you

Nataliya [291]

Answer:

Option B is correct.

The leads should be attached to the opposite faces that measure 3 cm × 5 cm to obtain the maximum possible resistance.

Explanation:

The resistance of a material is given by

R = (ρL)/A

where ρ = resistivity of the material

A = Cross sectional Area through which current would flow

L = length of the material.

From the relation, it is evident that the resistance of a material is directly proportional to its length and inversely proportional to its cross sectional Area.

As the length of material increases, the resistance of the material also increases, and a decreasing length translates to a decreasing resistance too. (Direct Proportionality)

And as the cross sectional Area of the material increases, the resistance of the material decreases. Decrease in cross sectional Area of the material translates to an increase in resistance. (Inverse Proportionality)

To maximize resistance of a material, it would make sense to maximize the length and minimize the cross sectional Area of that material. (Since resistivity is assumed to be constant)

And with a dimension of (3 × 5 × 8), the longest length is 8 cm and the smallest cross sectional Area is (3 × 5).

So, the leads should be atrached to the face with area (3 cm × 5 cm), which is the smallest cross sectional Area and gives the largest length between the faces (8 cm).

This subsequently maximizes the resistance.

Hope this Helps!!!

4 0

3 years ago

Read 2 more answers

Fig. 2.1 shows the extension-load graph for a spring.

trapecia [35]

Answer:

(1) Hooke's law

(2) a) Extension is directly proportional to the applied load

b) The starting point of the graph is the origin (0, 0) or absence of load, no extension

Explanation:

(1) The law obeyed by the spring is known as Hooke's law which states that the extension or compression, x, of a spring proportional to the applied force, F

F = -k × x

Where;

k = The spring constant

(2) Given that the law mathematically is F = -k × x

The two features of the graph that show that the law is obeyed are;

a) The extension increases as the load is increased

b) The extension is zero when the there is no applied load.

3 0

3 years ago

Two trains start a journey at the same time 120 miles apart, travelling towards each other. The first train is travelling at 60

Ludmilka [50]

The space between them is shrinking at (60+40)= 100 mph. It started out being 120 miles. To shrink to zero will take

(120 miles) / (100 mph) = 1.2 hours

That's 1 hour and 12 minutes.

7 0

3 years ago

The nucleus of some isotopes will spontaneously undergo nuclear decay. These isotopes are said to be radioactive. What causes th

Dmitry_Shevchenko [17]

Answer:

Here, he is able both to share his own suffering and—in a way that Mammy cannot—insist on his love for Laila. Babi's dream for leaving Afghanistan is, ironically, based in his love for the country—a love he thinks can be better kept alive by continuing to celebrate its culture and cuisine abroad.JThe nucleus of some isotopes will spontaneously undergo nuclear decay. These isotopes are said to be radioactive. What causes the nucleus of an isotope to be radioactive?

The electric force and nuclear forces are in opposition to each other

Nuclear forces disintegrate protons

There are too many electrons in its orbitals

The electric force causes electrons to be released

(please help i genuinely cant find out why)Babi had wanted Laila and Tariq to understand their country's living, breathing heritage—a heritage quite apart from the violence and turmoil of the national wars. The Buddhas, testimony to an ancient community of monks that lived in caves within the cliffs, symbolize the cultural richness of this national heritageAs an unstable atom tries to reach a stable form, energy and matter are released from the nucleus. This spontaneous change in the nucleus is called radioactive decay. When there is a change in the nucleus and one element changes into another, it is called transmutation.Carbon-14 is unstable and undergoes radioactive decay with a half-life of about 5,730 years (meaning that half of the material will be gone after 5,730 years). This decay means the amount of carbon-14 in an object serves as a clock, showing the object's age in a process called “carbon dating.”Nuclear decay occurs when the nucleus of an atom is unstable and spontaneously emits energy in the form of radiation. The result is that the nucleus changes into the nucleus of one or more other elements. These daughter nuclei have a lower mass and are more stable (lower in energy) than the parent nucleus.

7 0

2 years ago

Which part of the roller coaster system determines the amount of kinetic energy in the system

eduard

The lowest point, where the amount of energy is the greatest

5 0

4 years ago

Read 2 more answers