No icicles are water made up of atoms not cells
Answer:
Option 2 is correct.
Scintillation counters and Geiger Counters provide instantaneous measure of radioactivity.
Explanation:
Of the three means of measuring radioactivity presented. Only Film-badge dosimeter lacks a sensitive photo-detector piece that instantaneously converts the amount of radiation seen into electrical waves. It collects the radiation over time and the film is then developed after a particular point in time for the radioactivity collected to be measured.
Although used majorly for gamma rays and neutrons, the scintillation counters uses a scintillator to convert ionizing radiation (like the two mentioned at the start of this passage), into photons that the photo-detector (usually very sensitive) converts into electrical signals for immediate reading. It gives the energy and intensity of the radiation intended to.be measured.
The Geiger Muller counter, the most used measure of radioactivity across all fields, uses the tube (which contains inert gases) as the sensitive radiation detecting piece. High voltage maintained in the tube makes the gases conductive and it transmits the intemsity of radiation to the processing part of the counter which converts this reading to electrical signals, immediately for reading. Unlike the scintillation counters, it doesn't measure the energy of the radiation.
Hope this Helps!!!
Hello
We know that polar molecules' attraction is stronger than that of non polar ones; this can be a good basis for us to check the substances' polarity. Knowing that polar forces are stronger, we can eliminate all options referring to them as being the weaker force; that is, options C and A. Next, we know that stronger forces will result in lower volatility so we can eliminate option D. The answer is B, assuming the compound has an odor.
Answer:
a.
Explanation:
Assuming that Liquid X is considered to possess a greater viscosity as well as higher surface tension than liquid Y. Then, liquid X will tend to harbour more pressure inside the liquid.
In addition to that, the greater the surface tension, the greater the force required to expand the liquid's surface area.
This in turn makes the force required to make the loop 5% wider to be greater in FX rather than FY.
Thus, option a is the correct answer.
We can predict the order of the elements given above according from the highest to lowest first ionization energies by using the trends in a periodic table. For elements in a family, the ionization energy decreases as it goes down. Therefore, the correct order would be Be, Mg, Ca, Sr.
