2000/18 =111.111111
111.1 moles
Answer:
C) a low heat of vaporization.
Explanation:
It is C) a low heat of vaporization.
Low heat of vaporization means less amount of energy is required to vaporize a liquid. This further means the liquid has weaker intermolecular force of attraction that is why on provide lesser heat only it vaporizes.
Low vapor pressure, high boiling point and high critical temp. all contribute to strong intermolecular forces in a liquid
Answer:
See balanced equations below
Explanation:
1. Mg(s) +2 HCL (aq) →MgCl₂ (aq) +H₂(g)
This is a single replacement reaction, involving an acid with a metal
2. 2Al(s) + 3H₂SO₄ (aq)→Al₂(SO₄)₃(aq) + 3H₂
3. 3 Zn (s) + 2H₃PO₄(aq)→ Zn₃(PO₄)₂ (aq) + 3H₂ (g)
4. 2Al(s) + 6HCL (aq)→2AlCl₃(aq) +3H₂ (g)
B.
1. 2KOH(aq) + MgCl₂→Mg(OH)₂ (aq) + 2KCl (aq)
2. 3NaOH (aq)+ Al(NO₃)₃ (aq)→Al(OH)₃(s) + 3 NaNO₃(aq) ---this is a precipitation reaction
3. BaBr₂(aq) + H₂SO₄→BaSO₄ (s) + 2Br⁻(aq)
4. Na₂S + 2HCl → 2NaCl (aq) + H₂S (g)
5. 3CaCl₂ +2K₃PO₄→ Ca₃(PO₄)₂+6KCl
6.Ba(NO₃)₂ + (NH₄)₂CO₃→ 2(NH₄)⁺(aq) +BaCO₃(s)
Answer:
You find a separatory funnel set up in a fume hood. There are clearly two visible layers. Describe a method you could use to determine which layer is the aqueous layer.
Explanation:
In the separating funnel, the liquid with less density exists at the top layer and the liquid with greater density will exist at the bottom layer.
To identify the aqueous layer, add a bit of water to the separating funnel.
Then, observe where the water will go and mix.
If it mixes with the bottom layer, then the bottom layer is the aqueous layer.
If water mixes with the top layer, then top layer is the aqueous layer.
That would be called gas.
