Answer: 406 hours
Explanation:

where Q= quantity of electricity in coloumbs
I = current in amperes = 39.5 A
t= time in seconds = ?
The deposition of copper at cathode is represented by:

Coloumb of electricity deposits 1 mole of copper
i.e. 63.5 g of copper is deposited by = 193000 Coloumb
Thus 19.0 kg or 19000 g of copper is deposited by =
Coloumb

(1hour=3600s)
Thus it will take 406 hours to plate 19.0 kg of copper onto the cathode if the current passed through the cell is held constant at 39.5 A
Answer:

Explanation:
In this case, we can start with the <u>formula of Platinum (II) Chloride</u>. The cation is the atom at the left of the name (in this case
) and the anion is the atom at the right of the name (in this case
). With this in mind, the <u>formula would be</u>
.
Now, if we used <u>metallic copper</u> we have to put in the reaction only the <u>copper atom symbol</u>
. So, we have as reagents:

The question now is: <u>What would be the products?</u> To answer this, we have to remember <u>"single displacement reactions"</u>. With a general reaction:

With this in mind, the reaction would be:

I hope it helps!
Question:
Sulfuric acid was once produced through the reaction of sulfur trioxide with water. Sulfur trioxide can form through the reaction of sulfur dioxide and oxygen gas. When nitrogen monoxide gas is added to the system, the reaction speeds up significantly because it proceeds through the following steps:
equations
Identify the catalyst in this reaction, explain how you know it is the catalyst, and describe how it increases the rate of the reaction.
Answer:
NO
It is present but not consumed
NO Lowers the activation energy of the reaction
Explanation:
A catalyst is a substance that is present in a chemical reaction and enables the reaction to occur at a faster rte but does not take part n the reaction
Therefore, whereby NO is not consumed, it is the catalyst
It functions by lowering the activation energy
Polyethene is a polymer composed of repeating units of the monomer ethene.
The properties of polyethene are as follows:
- density- ranges 0.857 g/cm3 to 0.975 g/cm3.
- specific heat capacity is 1.9 kJ/kg.
- melting temperature is approximately 110 °C.
<h3>What are polymers?</h3>
Polymers are large macromolecules consisting of long repeating chains of smaller molecules known as monomers.
An example of a polymer is polyethene composed of repeating units of the monomer ethene.
The density of polyethylene ranges 0.857 g/cm3 to 0.975 g/cm3.
The specific heat capacity of polyethene is 1.9 kJ/kg.
The melting temperature of polyethene is approximately 110 °C.
Learn more about polyethene at: brainly.com/question/165779