Profit = Income - cost
Profit = 10s - (28 + 3s) = 10s - 28 -3s = 7s - 28.
Profit = 0
0 = 7s - 28
7s = 28
7s = 28/7
s = 4. This is the breakeven point.
Carlota must sell more than 4 shirts to make a profit
20/28 or 10/14 or 5/7
You can keep reducing until both sides of the fraction can't be divided by the same number anymore.
Data:
x: number of months
y: tree's height
Tipical grow: 0.22
Fifteen months into the observation, the tree was 20.5 feet tall: x=15 y=20.5ft (15,20.5)
In this case the slope (m) or rate of change is the tipical grow.
m=0.22
To find the line's slope-intercep equation you use the slope (m) and the given values of x and y (15 , 20.5) in the next formula to find the y-intercept (b):

Use the slope(m) and y-intercept (b) to write the equation:

A) This line's slope-intercept equation is: y=0.22x+17.2
B) To find the height of the tree after 29 months you substitute in the equation the x for 29 and evaluate to find the y:

Then, after 29 months the tree would be 23.58 feet in height
C) In this case as you have the height and need to find the number of moths you substitute the y for 29.96feet and solve the equation for x, as follow:

Then, after 58 months the tree would be 29.96feet tall
Answer:
9r
Step-by-step explanation:
1.5r - 3r + 10.5r
10.5r + 1.5r = 12r
12r - 3r = 9r
Final Answer = 9r
Answer:
see below
Step-by-step explanation:
A protractor is usually a transparent measuring device laid intended to be laid over an angle to be measured. The centerpoint of the protractor's scale is made to coincide with the angle's vertex, and the baseline of the protractor is aligned with one of the angle's rays. The appropriate scale is used to read the angle where the other ray crosses the scale. You usually have to visually determine if the angle is acute or obtuse, so you can choose the correct scale to read.
__
If you're drawing an angle, first draw one ray and locate the vertex on it. Then do the steps above as you would for measurement. Make a mark on your paper corresponding to the desired angle measure, and connect the vertex to that mark to create the other ray of the angle.
__
If you're working with a printed protractor, you may need to do your work on a piece of translucent paper or transparency material, so you can see the protractor scale through the page you're drawing on.
_____
<em>Comment on a printed protractor</em>
A protractor will only give accurate measurements if its geometry is perfect. Some printers will scale a figure differently in horizontal and vertical directions, so will make the protractor scale be elliptical instead of circular. That will give wrong readings.