Answer:
54 grams ammonium chloride and 40 grams sodium hydroxide
Explanation:
A buffer is a solution that contains either a weak acid and its salt or a weak base and its salt, the solution is resistant to changes in pH. This means that, a buffer is an aqueous solution of either a weak acid and its conjugate base or a weak base and its conjugate acid.
A Buffer is used to maintain a stable pH in a solution, buffers can neutralize small quantities of additional acid of base. For any buffer solution, there is always a working pH range and a set amount of acid or base that can be neutralized before the pH will change. The amount of acid or base that can be added to a buffer before changing its pH is called its buffer capacity.
A good buffer mixture is supposed to have about equal concentrations of its both components. It is a rule of thumb therefore, that a buffer solution has generally lost its usefulness when one component of the buffer pair is less than about 10% of the other component.
The implication of this is that the ammonium chloride and sodium hydroxide should be of approximately the same concentration. If the masses are dissolved as shown in the answer, then we will have 1molL-1 of each component of the buffer in accordance with the rule of thumb stated above.
Answer:
Carnivorous plants are easy to grow, if you follow a few, simple rules.
Wet all of the time.
Mineral-free water.
Mineral-free soil.
Lots of light.
Wet all of the time.
Carnivorous plants are native to bogs and similar nutrient-poor habitats. As a consequence, the plants live in conditions that are constantly damp. To grow healthy carnivorous plants, it is important to duplicate their habitat as closely as possible. Keep the soil wet or at least damp all of the time. The easiest way to do this is use the tray method. Set the pots in a tray or saucer, and keep water in it at all times. Pitcher plants can grow in soggy soil with the water level in the saucer as deep as 1/2 the pot, but most carnivorous plants prefer damp to wet soil, so keep the water at about 1/4 inch and refill as soon as it is nearly gone. Water from below, by adding water to the tray, rather than watering the plant. This will avoid washing away the sticky muscilage of the sundews and butterworts and keep from closing the flytraps with a false alarm.
Mineral-free water.
Always use mineral-free water with your carnivorous plants, such as rainwater or distilled water. Try keeping a bucket near the downspout to collect rainwater. Distilled water can be purchased at the grocery store, but avoid bottled drinking water. There are simply too many minerals in it. The condensation line from an air conditioner or heat pump is another source of mineral-free water. Reverse-osmosis water is fine to use. Carnivorous plants grow in nutrient poor soils. The minerals from tap water can “over-fertilize” and “burn out” the plants. In a pinch, tap water will work for a short while, but flush out the minerals with generous portions of rainwater, when it is available.
Mineral-free soil.
The nutrient poor soils to which the carnivorous plants have adapted are often rich in peat and sand. This can be duplicated with a soil mixture of sphagnum peat moss and horticultural sand. Be sure to check the peat label for sphagnum moss. Other types will not work well. The sand should be clean and washed. Play box sand is great, and so is horticultural sand. Avoid “contractor’s sand” which will contain fine dust, silt, clay and other minerals. Never use beach sand or limestone based sand. The salt content will harm the plants. The ratio of the mix is not critical, 1 part peat with 1 part sand works well for most carnivorous plants. Flytraps prefer a bit more sand, and nepenthes prefer much more peat. Use plastic pots, as terra cotta pots will leach out minerals over time and stress your plants.
Explanation:
Kayo na Po bahala magpaigsi
Answer:
A synthetic element is one of 24 chemical elements that do not occur naturally on Earth: they have been created by human manipulation of fundamental particles in a nuclear reactor, a particle accelerator, or the explosion of an atomic bomb; thus, they are called "synthetic", "artificial", or "man-made".
Explanation: hope that helps
The grams of carbon dioxide that are in 35.6 liters of Co2 is calculates as below
calculate the number of moles of CO2
At STP 1 mole = 22.4 L
what about 35.6 liters
= 1mole x 35.6 liters/ 22.4 liters = 1.589 moles
mass of CO2 = moles x molar mass of CO2
= 1.589 mol x 44 g/mol = 69.92 grams
