Having straight ears (E) is dominant over droopy ears

At a fixed depth within a fluid at rest, the pressure pushing upward is

earnstyle [38]

Answer: E) A) salt water.

Explanation:

E) In equilibrium, pressure exerts equally in all directions, so for a given depth, the pressure is the same for all points located at the same depth, and it can be written as follows:

p = p₀ + ρ.g.h, where p₀ = atmospheric pressure, ρ=fluid density, h=depth from the surface.

A) The buoyant force, as discovered by Archimedes, is an upward force, that opposes to the weight of an object (as it is always downward), and is equal to the weight of the volume of the liquid that the object removes, which means that is proportional to the density of the liquid.

As salt water is denser than fresh water, the buoyant force exerted by the salt water is always greater than the one produced by the fresh water, so objects will float more easily in salt water than in fresh water.

In the limit, it is possible that one object float in salt water and sink in fresh water.

3 0

4 years ago

How much energy is required to change a 44 g

zlopas [31]

Answer:

Ang answer units of J heat of fusion is 3.33 x 105

4 0

3 years ago

series RC circuit is built with a 15 kΩ resistor and a parallel-plate capacitor with 18-cm-diameter electrodes. A 18 V, 36 kHz s

andre [41]

Answer:

$d=1.84\ mm$

Explanation:

<u>Capacitance</u>

A two parallel-plate capacitor has a capacitance of

$\displaystyle C=\frac{\epsilon_o A}{d}$

where

$\epsilon_o=8.85\cdot 10^{-12}\ F/m$

A = area of the plates = $\pi r^2$

d = separation of the plates

$\displaystyle d=\frac{\epsilon_o A}{C}=\frac{\epsilon_o \pi r^2}{C}$

We need to compute C. We'll use the circuit parameters for that. The reactance of a capacitor is given by

$\displaystyle X_c=\frac{1}{wC}$

where w is the angular frequency

$w=2\pi f=2\pi \cdot 36000=226194.67\ rad/s$

Solving for C

$\displaystyle C=\frac{1}{wX_c}$

The reactance can be found knowing the total impedance of the circuit:

$Z^2=R^2+X_c^2$

Where R is the resistance, $R=15 K\Omega=15000\Omega$ . Solving for Xc

$X_c^2=Z^2-R^2$

The magnitude of the impedance is computed as the ratio of the rms voltage and rms current

$\displaystyle Z=\frac{V}{I}$

The rms current is the peak current Ip divided by $\sqrt{2}$ , thus

$\displaystyle Z=\frac{\sqrt{2}V}{I_p}$

$I_p=0.65\ mA/1000=0.00065\ A$

Now collect formulas

$\displaystyle X_c^2=Z^2-R^2=\left(\frac{\sqrt{2}V}{I_p}\right)^2-R^2$

Or, equivalently

$\displaystyle X_c=\sqrt{\frac{2V^2}{I_p^2}-R^2}$

$\displaystyle X_c=\sqrt{\frac{2\cdot 18^2}{0.00065^2}-15000^2}$

$X_c=36176.34\ \Omega$

The capacitance is now

$\displaystyle C=\frac{1}{226194.67\cdot 36176.34}=1.22\cdot 10^{-10}\ F$

The radius of the plates is

$r=18\ cm/2=9 \ cm = 0.09 \ m$

The separation between the plates is

$\displaystyle d=\frac{8.85\cdot 10^{-12} \cdot \pi\cdot 0.09^2}{1.22\cdot 10^{-10}}$

$d=0.00184\ m$

$\boxed{d=1.84\ mm}$

8 0

3 years ago

What is the smallest possible wavelength of light?

lilavasa [31]

Explanation:

Blue or violet light has the shortest wavelength. White light is a combination of all colors in the color spectrum.

7 0

3 years ago

Problem 4: A uniform flat disk of radius R and mass 2M is pivoted at point P A point mass of 1/2 M is attached to the edge of th

brilliants [131]

From the case we know that:

The moment of inertia Icm of the uniform flat disk witout the point mass is Icm = MR².
The moment of inerta with respect to point P on the disk without the point mass is Ip = 3MR².
The total moment of inertia (of the disk with the point mass with respect to point P) is I total = 5MR².

Please refer to the image below.

We know from the case, that:

m = 2M

r = R

m2 = 1/2M

distance between the center of mass to point P = p = R

Distance of the point mass to point P = d = 2R

We know that the moment of inertia for an uniform flat disk is 1/2mr². Then the moment of inertia for the uniform flat disk is:

Icm = 1/2mr²

Icm = 1/2(2M)(R²)

Icm = MR² ... (i)

Next, we will find the moment of inertia of the disk with respect to point P. We know that point P is positioned at the arc of the disk. Hence:

Ip = Icm + mp²

Ip = MR² + (2M)R²

Ip = 3MR² ... (ii)

Then, the total moment of inertia of the disk with the point mass is:

I total = Ip + I mass

I total = 3MR² + (1/2M)(2R)²

I total = 3MR² + 2MR²

I total = 5MR² ... (iii)

Learn more about Uniform Flat Disk here: brainly.com/question/14595971

#SPJ4

8 0

2 years ago