The answer is B. The electric screw driver increased the work. You would rather have an electric one than doing it all by hand. Hope this helps!
Answer:
it may be efficient at first but over time there will be a lot of wasted energy.
Explanation:
I'm pretty sure
So it doesnt get over heated ...
A cooling system<span> works by sending a liquid </span>coolant<span> through passages in the </span>engine<span>block and heads. As the </span>coolant<span> flows through these passages, it picks up heat from the </span>engine<span>. The heated fluid then makes its way through a rubber hose to the radiator in the front of the </span>car<span>.</span>
Answer:
I. Stopping acceleration = 6 m/s²
II. Stopping distance, S = 75 meters
Explanation:
Given the following data;
Final velocity = 30 m/s
Time = 5 seconds
To find the stopping acceleration;
Mathematically, acceleration is given by the equation;

Substituting into the equation;
Acceleration = 6 m/s²
II. To find the stopping distance, we would use the third equation of motion;
Where;
V represents the final velocity measured in meter per seconds.
U represents the initial velocity measured in meter per seconds.
a represents acceleration measured in meters per seconds square.
Substituting into the equation, we have;
30² = 0² + 2*6*S
900 = 12S
S = 900/12
S = 75 meters