The carriage handwheel is used to manually position and/or hand feed the carriage in the longitudinal or Z axis.
IamSugarBee
Answer:
T = 15 kN
F = 23.33 kN
Explanation:
Given the data in the question,
We apply the impulse momentum principle on the total system,
mv₁ + ∑ = mv₂
we substitute
[50 + 3(30)]×10³ × 0 + FΔt = [50 + 3(30)]×10³ × ( 45 × 1000 / 3600 )
F( 75 - 0 ) = 1.75 × 10⁶
The resultant frictional tractive force F is will then be;
F = 1.75 × 10⁶ / 75
F = 23333.33 N
F = 23.33 kN
Applying the impulse momentum principle on the three cars;
mv₁ + ∑ = mv₂
[3(30)]×10³ × 0 + FΔt = [3(30)]×10³ × ( 45 × 1000 / 3600 )
F(75-0) = 1.125 × 10⁶
The force T developed is then;
T = 1.125 × 10⁶ / 75
T = 15000 N
T = 15 kN
Answer:
Check the Attached Image
Explanation:
The full solution is in the attached image below
Answer:
Ts = 413.66 K
Explanation:
given data
temperature = 20°C
velocity = 10 m/s
diameter = 5 mm
surface emissivity = 0.95
surrounding temperature = 20°C
heat flux dissipated = 17000 W/m²
to find out
surface temperature
solution
we know that here properties of air at 70°C
k = 0.02881 W/m.K
v = 1.995 × m²/s
Pr = 0.7177
we find here reynolds no for air flow that is
Re =
Re =
Re = 2506
now we use churchill and bernstein relation for nusselt no
Nu = = 0.3 +
h = 0.3 +
h = 148.3 W/m².K
so
q conv = h∈(Ts- T∞ )
17000 = 148.3 ( 0.95) ( Ts - (20 + 273 ))
Ts = 413.66 K
Answer:
The correct option is;
c. Leaving the chuck key in the drill chuck
Explanation:
A Common safety issues with a drill press leaving the chuck key in the drill chuck
It is required that, before turning the drill press power on, ensure that chuck key is removed from the chuck. A self ejecting chuck key reduces the likelihood of the chuck key being accidentally left in the chuck.
It is also required to ensure that the switch is in the OFF position before turning plugging in the power cable
Be sure that the chuck key is removed from the chuck before turning on the power. Using a self-ejecting chuck key is a good way of insuring that the key is not left in the chuck accidentally. Also to avoid accidental starting, make sure the switch is in the OFF position before plugging in the cord. Always disconnect the drill from the power source when making repairs.