It costs 300
Perimeter = 2(L+B)
2(10+5)
2(15) = 30
10 — 1metre
X — 30metres
30metres = 300
Hope that helps :)
Answer:
(a) Frequency induced voltage of motor is 120 Hz
(b) The speed at which the machine will produce an average torque is 240π rad/s. Maximum Torque is 1.0 Nm
Explanation:
What torque specs to heads bolts need to be at for a 76 small block chevy is given below
Explanation:
1.Always torque bolts in three equal increments
Bolts or Parts Lube or Sealer Torque to:
Cylinder Heads Engine oil (blind hole) Sealer (water jacket) 65 ft-lbs.
Rocker Studs (screw-in) Engine Oil 50 ft-lbs.
2.Intake Manifold to Cylinder Head
- In the GM 350-cubic-inch engine, the intake manifold bolts to the cylinder head with 33 foot-pounds of torque.
3.Torque the head bolts in the same manner in three stages. Start by tightening all the bolts in sequence to 45 pounds of torque, then to 75 and finally to the torque recommended. Depending on the type of head you are installing, the final torque number will be different.
4.Bolts with any signs of damage, no matter how slight, should never be reused. Not only will the bolts eventually fail, but when they do, there is the potential for them to cause damage to your cylinder head. This results in a much more expensive repair than simply replacing the bolts in the first place.
5.The Chevy 350 engine is a 350 cubic inch (5.7-liter) small block V8 with a 4.00 and 3.48 inch bore and stroke. Depending on the year, make and model of a car, horsepower ranges from approximately 145 to more than 370.
Answer:
Taking responsibility for your own learning makes it easier to identify your strengths and weaknesses. Once these have been identified you can work on a learning plan that focuses on the areas that you need most help with, increasing the speed of your learning, and build the skills you have been trying to perfect.
Explanation:
Answer:
Explanation:
Given that:
Torque T = 2300 lb - ft
Bending moment M = 1500 lb - ft
axial thrust P = 2500 lb
yield points for tension σY= 100 ksi
yield points for shear τY = 50 ksi
Using maximum-shear-stress theory
where;
where;
Let say :
Then :
According to trial and error;
c = 0.75057 in
Replacing c into equation (1)
The required diameter d = 2c
d = 1.50 in or 0.125 ft