Answer:
Explanation:
A 12.48 g sample of an unknown metal, heated to 99.0 °C was then plunged into 50.0 mL of 25.0 °C water. The temperature of the water rose to 28.1 Go to calculating final temperature when mixing two samples of water ... Problem #1: A 610. g piece of copper tubing is heated to 95.3 °C and placed in an ... The two rings are heated to 65.4 °C and dropped into 12.4 mL of water at 22.3 °C. ... Problem #4: A 5.00 g sample of aluminum (specific heat capacity = 0.89 J g¯1
Answer:
8.73
Explanation:
when you are adding or subtracting numbers, the sigfig (significant figure) is based on how many numbers after the decimal. with this info, we can see that 15.67 has 2 sigfigs and 6.943 has 3 sigfigs. when you subtract normally, you would get 8.727, which has 3 sigfigs, so you would round the last 7 up to get 8.73 with 2 sigfigs!
also it is to 2 sigfigs because we know that we go by the least number of sigfigs. hope this helped!
Answer:
A3+ and B-
Explanation:
Elements in group 13 have outermost electron configuration, ns2np1 hence they form trivalent positive ions.
Elements in group 17 have outermost electron configuration ns2np5 hence they form univalent negative ions.
This implies that, if element A is in Group 13 and element B is in Group 17, the ions formed are A3+ and B-.
iii. True. The existence of a vacancy in a crystal decreases the energy of the material.
One of the scientific disciplines called crystallography examines how the atoms in a solid crystal are arranged. When molecules are linked together in a regular way, these crystals are created.
The mechanical, physical, and optical properties of a material can alter when crystal flaws are present. The strength of the material can be impacted by a flaw.
An irregularity in the atoms' regular geometrical arrangement within a crystalline material is referred to as a crystal defect. These flaws are caused by the solid being deformed, cooling quickly from a high temperature, or being exposed to high-energy radiation (such as X-rays or neutrons). because the vacancy cause defects and the crystal structure is disturbed this causes a decrease in energy.
To know more about vacancy visit the link:
brainly.com/question/14937309?referrer=searchResults
#SPJ4
Answer:
b) The dehydrated sample absorbed moisture after heating
Explanation:
a) Strong initial heating caused some of the hydrate sample to splatter out.
This will result in a higher percent of water than the real one, because you assume in the calculation that the splattered sample was only water (which in not true).
b) The dehydrated sample absorbed moisture after heating.
Usually inorganic salts may absorbed moisture from the atmosphere so this will explain the 13% difference between calculated water percent the real content of water in the hydrate.
c) The amount of the hydrate sample used was too small.
It will create some errors but they do not create a difference of 13% difference as stated in the problem.
d) The crucible was not heated to constant mass before use.
Here the error is small.
e) Excess heating caused the dehydrated sample to decompose.
Usually the inorganic compounds are stable in the temperature range of this kind of experiments. If you have an organic compound which retain water molecules you may decompose the sample forming volatile compounds which will leave crucible so the error will be quite high.
