Answer:
50421.6 m³
Explanation:
The river has an average rate of water flow of 59.6 m³/s.
Tributary B accounts for 47% of the rate of water flow. Therefore the rate of water flow through tributary B is:
Flow rate of water through tributary B = 47% of 59.6 m³/s = 0.47 * 59.6 m³/s = 28.012 m³/s
The volume of water that has been discharged through tributary B = Flow rate of water through tributary B * time taken
time = 30 minutes = 30 minutes * 60 seconds / minute = 1800 seconds
The volume of water that has been discharged through tributary B in 30 seconds = 28.012 m³/s * 1800 seconds = 50421.6 m³
Answer:
The shear strain is 0.05797 rad.
Explanation:
Shear strain is the ratio of change in dimension along the shearing load direction to the height of the plate under application of shear load. Width of the plate remains same. Length of the plate slides under shear load.
Step1
Given:
Height of the pad is 1.38 in.
Deformation at the top of the pad is 0.08 in.
Calculation:
Step2
Shear strain is calculated as follows:
For small angle of , can take as.
Thus, the shear strain is 0.05797 rad.
C, being able to maintain legal information on grant programs
Answer:
Reflexive Property
Explanation:
Just got the answer right on a quiz
A good source of insight to the technician about an engine's condition is the noises coming from the engine
The correct option that gives the exception to the noises heard during a cranking sound diagnosis is the option;
- b. <u>The engine revving and starting up</u>
Reason:
During a cranking sound diagnosis, the engine need to be disabled to
prevent it from starting, which is done by removing the relay for the fuel
pump, which will prevent fuel from potentially hydro-locking the engine
The key is then used to crank the engine, during which the cranking sound
is listened to
The sources of the noises produced includes;
- The starter is misaligned
- The clunk of a spun crankshaft bearing noise
- The sound given by a low compression cylinder, which is an uneven sound
- The no compression condition fast cranking sound, due to broken time belt that results in bent valves
Therefore;
The exception to the sounds heard during a cranking sound diagnosis is; <u>The engine revving and starting up</u>
Learn more here:
brainly.com/question/18457057