All categories

3 years ago

Who else ships it????????

Engineering

1 answer:

german3 years ago

6 0

Answer: I MOST DEFENTALLY SHIP CORPSE AND SYKKUNO YASSSS

Explanation:

Can u plz mark the branliest

#Corpse and Sykkuno

You might be interested in

A fluid flows through a 10-mm diameter tube at a Reynolds number of 1800. If the flow rate is 6.0 liters/min, what is the head l

Eddi Din [679]

Answer:

29.31 m

Explanation:

It is given that flow rate Q =6.0 ltrs/minute $=\frac{6}{1000\times 60}$ $m^3/sec$

Diameter =10 mm

So radius = $\frac{10}{2}=5 mm=5\times 10^{-3}m$

Area of duct $A=\pi r^2=3.14\times(5\times 10^{-3})^2=7.854 \times 10^{-5}m^2$

Average velocity $v=\frac{Q}{A}=\frac{10^{-4}}{7.854\times 10^{-5}}=1.372 m/sec$

The given Reynolds number is 1800 which is less than 2000 so it will be a laminar flow

So Reynolds number friction factor $f=\frac{64}{1800}=0.0356$

So head loss ifs given by $\frac{fLv_{avg}^2}{d\times 2\times g}=\frac{0.0356\times 100\times 1.732^2}{10\times 10^{-3}\times 2\times 9.81}=29.39\ m$

5 0

3 years ago

How do you build a engine best anwser will get marked as brainlist

marysya [2.9K]

Answer:

It is best to soak the new lifters in engine oil overnight in order to build a car engine from scratch, regardless of its length. Ensure all rings of the pistons are installed correctly. You should flip the block over and carefully install the top half of the main rod and bearing parts. Get the block out of your way and flip it over again. By flipping over the block, you’ll see the full effect. Ensure that the lifters are installed correctly.

Explanation:

5 0

2 years ago

If a condenser has high head pressure and a higher than normal temperature, a technician could ____.

katrin2010 [14]

clean the tubes and fins with a high-pressure jet of air or mechanical scrubbing

ensure that the condenser fans are operating properly

6 0

3 years ago

For RTK to work, what do we need besides two or more receivers collecting data from a sufficient number of satellites simultaneo

Liula [17]

Answer:

phase measurement and the information content

Explanation:

The full form of RTK is Real Time Kinematic. It is used for satellite navigation technique to increase the precision of the position data that is derived from the positioning systems based on satellites like the NavIC, GPS, Galileo, BeiDou and GLONASS. It takes help of the measurements of phase of signal's carrier wave and also the information content of these signals and it also relies on the single interpolated virtual station in order to provide the real time corrections and provide correct and accurate information.

7 0

3 years ago

EJERCICIO 6

Ket [755]

Answer:

mnfokfnfi3or

Explanation:

can you translate it into english.....

8 0

3 years ago