Answer:
MRR = 1.984
Explanation:
Given that
Depth of cut ,d=0.105 in
Diameter D= 1 in
Speed V= 105 sfpm
feed f= 0.015 ipr
Now the metal removal rate given as
MRR= 12 f V d
d= depth of cut
V= Speed
f=Feed
MRR= Metal removal rate
By putting the values
MRR= 12 f V d
MRR = 12 x 0.015 x 105 x 0.105
MRR = 1.984
Therefore answer is -
1.944
Answer:
The frequency that the sampling system will generate in its output is 70 Hz
Explanation:
Given;
F = 190 Hz
Fs = 120 Hz
Output Frequency = F - nFs
When n = 1
Output Frequency = 190 - 120 = 70 Hz
Therefore, if a system samples a sinusoid of frequency 190 Hz at a rate of 120 Hz and writes the sampled signal to its output without further modification, the frequency that the sampling system will generate in its output is 70 Hz
Answer:
If it is rechargable, there should be instructions on it, but I believe you can recycle it. For single use batteries, they need to be put into a safe location as they can actually explode sometimes, and acid leaks can also occur.
Normally, you can use put something like electrical tape or a nonconductive material on top of both of the battery nodes and you can just toss it into a trash can.
Explanation:
What torque specs to heads bolts need to be at for a 76 small block chevy is given below
Explanation:
1.Always torque bolts in three equal increments
Bolts or Parts Lube or Sealer Torque to:
Cylinder Heads Engine oil (blind hole) Sealer (water jacket) 65 ft-lbs.
Rocker Studs (screw-in) Engine Oil 50 ft-lbs.
2.Intake Manifold to Cylinder Head
- In the GM 350-cubic-inch engine, the intake manifold bolts to the cylinder head with 33 foot-pounds of torque.
3.Torque the head bolts in the same manner in three stages. Start by tightening all the bolts in sequence to 45 pounds of torque, then to 75 and finally to the torque recommended. Depending on the type of head you are installing, the final torque number will be different.
4.Bolts with any signs of damage, no matter how slight, should never be reused. Not only will the bolts eventually fail, but when they do, there is the potential for them to cause damage to your cylinder head. This results in a much more expensive repair than simply replacing the bolts in the first place.
5.The Chevy 350 engine is a 350 cubic inch (5.7-liter) small block V8 with a 4.00 and 3.48 inch bore and stroke. Depending on the year, make and model of a car, horsepower ranges from approximately 145 to more than 370.
Answer:no fire can be used on fire
Explanation:
because no fire can be used on fire