Answer:
The meaurement of the amount of friction a surface will generate is called the coefficient of friction.
B! Assume you are lifting weights... you are squatting 100 pounds, then you go to 200 pounds. The force of the mass/weight thus double Bc it is twice as hard to push it up!!
Hope this helps
Answer:
Deposition
Explanation:
- Deposition occurs when water slows or ceases moving, the wind dies or stops blowing, or glaciers melt. The deposited material can also be used to construct new landforms. Waves, for example, can dump sediment in places offshore, where it might accumulate to form sand dunes.
When the wind calms down or vegetation stops or slows the breeze, the sediment particles begin to fall. Water is another factor that may erode, move, or deposit sediment. Flowing water is a key erosive agent. Water transports dirt and rock fragments as it moves. Warm, wet air will not travel if wind systems are not present. Water will still evaporate, but it will not move, therefore everywhere else than a major body of water will dry up. Lakes may be fine since evaporating water will flow back into them, and the sea will be fine, but everywhere else will become extremely dry very rapidly. Wind is constantly blowing somewhere on the world at any given time. Winds are usually quiet near the middle of a high pressure system. Wind is the passage of air from a high pressure location to a low pressure area.... So essentially air is always moving. Weathering and erosion are caused by wind. Weathering is caused by wind blowing debris against cliffs and huge rocks. This wears down the rock, reducing it to sand and dust. Sand and dust are also eroded by wind. 2. Rocks are tough and durable, but they don't last forever. Weathering and erosion are processes that occur as a result of forces such as wind and water breaking down rocks. Weathering is the process through which rocks deteriorate. Weathering is caused by a variety of factors, including climate change.
The nut distance from the Bullwinkle after uniform motion is 21 m.
We need to know about the uniform motion to solve this problem. The uniform motion is an object's motion under acceleration. It should follow the rule
vt = vo + a . t
vt² = vo² + 2a . s
s = vo . t + 1/2 . a . t²
where vt is final velocity, vo is initial velocity, a is acceleration, t is time and s is displacement.
From the question above, the parameters given are
m = 0.5 kg
s = 15 m
vx = 12 m/s
vo = 0 m/s
a = g = 9.8 m/s²
Find the time taken of the nut for landing
s = vo . t + 1/2 . a . t²
15 = 0 + 1/2 . 9.8 . t²
t² = 3.06
t = 1.75 s
Find the distance of nut in horizontal direction
vx = x / t
12 = x / 1.75
x = 12 . 1.75
x = 21 m
Find more on uniform motion at: brainly.com/question/28040370
#SPJ4
Answer:
D.
they are looking to find a doctor to give them a diagnosis
Explanation:
cause I had this answer