All categories

3 years ago

NO LINK ANSWERS NEED HELP FAST

Physics

2 answers:

Maru [420]3 years ago

8 0

Answer:

B would be the correct answer

Papessa [141]3 years ago

4 0

I think the answer would be B. The pressure inside the balloon would increase. Hope this help!

You might be interested in

Emily wanted to see what battery lasted the longest. She put each battery into a clock and recorded the time that the clock stop

AURORKA [14]

Answer:

This question is asking to identify the following variables:

Independent variable (IV): Battery

Dependent variable (DV): Time the clock stopped

Constant: Same clock

Control: No stated control

Explanation:

The independent variable in an experiment is the variable that is subject to manipulation or change by the experimenter. In this experiment, the independent variable is the BATTERIES (Duracell, Energizer, Kroger brand, EverReady).

The dependent variable is the variable that responds to the changes made to the independent variable. It is the variable that the experimenter measures. In this case, the dependent variable is the TIME IT TAKES FOR THE CLOCK TO STOP.

Constants or control variable is the variable that the experimenter keeps constant or unchanged for all groups throughout the experiment in order not to influence the outcome of the experiment. The constant in this case is the SAME CLOCK USED.

Control group is the group that does not receive the experimental treatment or independent variable in an experiment. In this case, all groups received a different kind of battery.

6 0

4 years ago

Truck drivers probably cannot see your vehicle if____.

laiz [17]

Answer Is Tailgating

6 0

3 years ago

At a given instant, the force on an electron is in the +z-direction (out of the page), which the electron is moving in the +x-di

Hitman42 [59]

Answer:

The direction of the B-field is in the +y-direction.

Explanation:

The corresponding formula is

$F_B = qv\times B$

This means, we should use right-hand rule.

Our index finger is pointed towards +x-direction (direction of velocity),

our middle finger should point towards the direction of the B-field,

and our thumb should point towards the +z-direction (direction of the force).

Since our middle finger in this situation points towards +y-direction, the B-field should be in +y-direction.

$\^{x} \times \^{y} = \^{z}$

3 0

4 years ago

Calculate, for the judge, how fast you were going in miles per hour when you ran the red light because it appeared Doppler-shift

sammy [17]

Answer:

The doppler effect equation is:

$f' = \frac{v +v0}{v - vs}*f$

In the equation we have frequencies, but then we have the wavelengths of the lights, remember the relation:

v = f*λ

then:

f = v/λ

and v is the speed of light, then:

f = c/λ

where:

f' is the observed frequency, in this case, is equal to f = (3*10^17nm/s)/550 nm

f is the real frequency, in this case, is (3*10^17nm/s)/650 nm

vs is the speed of the source, in this case, the source is not moving, then vs = 0 m/s.

v is the speed of the wave, in this case, is equal to the speed of light, v = 3*10^8 m/s

v0 is your speed, this is what we want to find.

Replacing those quantities in the equation, we get:

(3*10^17nm/s)/550 = (3*10^8 m/s + v0)/(3*10^8 m/s)*(3*10^17nm/s)/650 nm

(650nm)/(550nm) = (3*10^8 m/s + v0)/(3*10^8 m/s)

1.182*(3*10^8 m/s) = (3*10^8 m/s + v0)

1.182*(3*10^8 m/s) - (3*10^8 m/s) = v0 = 54,600,000 m/s

So your speed was 54,600,000 m/s, which is a lot.

6 0

3 years ago

How much heat would be needed to completely evaporate 31.5 g of boiling water at a temperature of 100 "C? Express your answer in

BaLLatris [955]

Answer:

Heat needed = 71.19 J

Explanation:

Here heat required can be calculated by the formula

H = mL

M is the mass of water and L is the latent heat of vaporization.

Mass of water, m = 31.5 g = 0.0315 kg

Latent heat of vaporization of water = 2260 kJ/kg

Substituting

H = mL = 0.0315 x 2260 = 71.19 kJ

Heat needed = 71.19 J

7 0

3 years ago