Answer:
A solution of NaOH has concentration 1.2M. Calculate the mass of NaOH in g/dm3 in this solution. = 1.2x 40x 1 = 48 g 3.
They are sometimes called inert gases. characteristics of matter that can be seen through direct observation such as density, melting point, and boiling point. Characteristics of matter that can only be observed when one substance changes into a different substance, such as iron into rust.
Answer: To calculate for the enthalpy of formation, it is the sum of all values of products - sum of all values of reactants.
Explanation:
I’m not sure what chemical reaction you are referencing to, but I attached an image below to help you see what I’m saying.
Answer:
b) Counter current
Explanation:
In mechanical, chemical, nuclear and other systems, it happens that heat must be transferred from one place to another or from one fluid to another. Heat exchangers are the devices that allow you to perform this task the types of exchangers are presented of heat as a function of flow: parallel flow; <u>counterflow</u>; cross flow.
Among the main reasons why exchangers are used
Heat are as follows:
• Heat a cold fluid using a fluid with a higher temperature.
• Reduce the temperature of a fluid by means of a fluid with a lower temperature.
• Bring the fluid to the boiling point using a fluid with a higher temperature.
• Condense a fluid in a gaseous state by means of a cold fluid
A backflow occurs when the two fluids flow in the same direction but in opposite way. Each of the fluids enters the exchanger through different ends Since the fluid with less temperature goes backflow from the heat exchanger at the end where the fluid enters with higher temperature, the temperature of the coldest fluid will approach the temperature of the inlet fluid.
This type of exchanger turns out to be more efficient than the other two types mentioned above. In contract with the exchanger parallel flow heat, the counterflow exchanger may have the highest temperature in the cold fluid and the lower temperature in the hot fluid after heat transfer in the exchanger.
<em>
Be careful with </em><u><em>turbulent</em></u><em> that it is not a type of exchanger but a system in which a fluid is found.</em>
