Both diamond and coal are formed by changes in pressure and temperature below the Earth's surface. The step in the formation of the minerals is <span>atoms break up in extreme heat. The answer is letter A.</span>
Answer:
c. nine times as low.
Explanation:
Sound intensity is defined as the acoustic power transferred by a sound wave per unit of normal area to the direction of propagation:
Since the sound wave has a spherical wavefront of radius r, then the area is given by:
Here r is the distance from the source of the sound. Thus sound intensity decreases as:
Electromagnetic waves need no matter to travel - they can travel through empty space (a vacuum). In a vacuum, all electromagnetic waves travel at approximately 3 x 108 m/s - which is the fastest speed possible. ...
Light traveling value through an optical Fibre is, 2 x 108 m/s. Hope that helps.
The force which has the greatest effect on causing this object to slow while it remains in contact with the ramp is: B. a frictional force.
<h3>What is a force?</h3>
A force can be defined as a push or pull of an object or physical body, which typically results in a change of motion (acceleration), especially due to the interaction of the object with another.
<h3>The types of force.</h3>
In Science, there are different types of force and these include the following:
<h3>What is a
frictional force?</h3>
Friction force can be defined as a type of force that resists and slows the relative motion of two physical objects when there surfaces come in contact. This ultimately implies that, a frictional force prevents two surfaces from easily sliding over or slipping across one another.
In this context, we can infer and logically deduce that the force which has the greatest effect on causing this object to slow while it remains in contact with the ramp is a frictional force.
Read more on frictional force here: brainly.com/question/25253774
#SPJ1
Complete Question:
Brandon pushes an object on a ramp as shown in the diagram.
While Brandon pushes the object and it remains in contact the ramp, which force has the greatest effect on causing it to slow?
A. the applied force
B. a frictional force
C. the force due to gravity
D. a force of air resistance
Factors affecting friction
The intensity of friction depends on following factors: i) The area involved in friction. ii) The pressure applied on the surfaces. Force = Pressure ´ Area Frictional force will increase, if the area of contact will increase or if pressure applied on the surface increased.
Methods to reduce friction
i) Polish the contact surface. ii) Put oil or grease so that it fills in the small gaps of the flat parts. iii) Use ball bearings to reduce area of contact between rotating parts.
Lubrication
Following methods can be used to reduce friction: Oil is either thin or viscous. It depends upon SAE No. of oil. (SAE means Society of Automotive Engineers). If we use very viscous oil, it does not reach all the parts. Very thin oil will flows away easily and gets wasted. Grease is used in such cases. It is generally used around ball-bearing. Normal grease or oil is never used where there is high pressure, high temperature and high speed. Special lubricants are used in such cases. In cold season the oil becomes thick and in hot season it becomes thin. Therefore selection of lubrication also depends on the season. It is always advisable to refer operating manual of the equipment before selecting the lubricant.
