Based on the information I would assume B, 73 degrees...
It shouldn't be A, 4 minutes on the burner should increase the temperature.
If it were D, it would be beyond boiling, and water takes a decent amount of energy to heat, D should be all vapor.
Same logic for C, it's basically almost boiling.
I would say 73 degrees seems most reasonable for 4 minutes.
Answer: The molar mass of H2S is greater than the molar mass of NH3, making the velocity and effusion rate of NH3 particles faster.
Effusion rate is inversely proportional to molar mass.
NH3 will have a higher average molecule velocity, so it will diffuse faster and will reach the other side of the room more quickly.
Explanation: change up your response a bit
First, we need to calculate moles of hydrazoic acid NH3:
moles NH3 = molarity * volume
= 0.15 m * 0.025 L
= 0.00375 moles
moles NaOH = molarity * volume
= 0.15 m * 0.015 L
= 0.00225 moles
after that we shoul get the total volume = 0.025L + 0.015L
= 0.04 L
So we can get the concentration of NH3 & NaOH by:
∴[NH3] = moles NH3 / total volume
= 0.00375 moles / 0.04 L
= 0.09375 M
∴[NaOH] = moles NaOH / total volume
= 0.00225 moles / 0.04 L
= 0.05625 M
then, when we have the value of Ka of NH3 so we can get the Pka value from:
Pka = -㏒Ka
= - ㏒ 1.9 x10^-5
= 4.7
finally, by using H-H equation we can get PH:
PH = Pka + ㏒[salt/ basic]
PH = 4.7 +㏒[0.05625/0.09375]
∴ PH = 4.48
Answer:
2.Closed System: A closed system is a thermodynamic system where energy can be exchanged with its surrounding but not matter. Open System: Open systems can exchange matter with the surrounding. Closed System: Closed systems cannot exchange matter with the surrounding. Open System: The mass of the system will vary with time in open systems.
Explanation:
1.The particle model is the name for the diagrams used to draw solids, liquids and gases. In the model, the particles are shown as circles or spheres. However, the particles in ice, liquid water and steam look the same because they are all water, but in different states of matter. Why do we use the particle model in science?
3.An open system can be defined as a system which can exchange both matter and energy with the surrounding. For example, the earth can be recognized as an open system. In this case, the earth is the system, and space is the surrounding. Sunlight can reach the earth surface and we can send rockets to space.
First M stands for Molarity which is (moles of solute) / (Liters of solution). we also know that moles = (mass) / (molar mass). so we can form some equations here. We know:
Molarity (M) = moles (mol) / Liters (L)
moles (mol) = (mass) / (molar mass)
we can substitute the (mass) / (molar mass) for (moles) and get:
M = [(mass) / (molar mass)] / Liters
we can now isolate mass and get
M * Liters * molar mass = mass
now we need to find the molar mass of CaCl2 which is 110.98 g/mol
plug the values in and get
.350M * 6.5L * 110.98 g/mol = mass
mass = 252.4795g however the 6.5L has only 2 sig figs so i would say
mass CaCl2 = 2.5 * 10 ^2 g
