All categories

3 years ago

When the rudder moves to the left the plane will move to the right or left?

Physics

2 answers:

Rina8888 [55]3 years ago

8 0

Answer:

The rudder will move to the right

Explanation:

This is using opposite forces and aircraft speeds to identify the modules used to make the rudder move the plane. If the rudder moves right, the plane goes left. If the rudder goes left, the plane goes right.

Hope this helped!

mrs_skeptik [129]3 years ago

5 0

To turn the aircraft, the pilot uses all three flight controls. The rudder is controlled in the cockpit by foot pedals. When the pilot presses the left pedal, the rudder deflects to the left. This deflection creates more lifting force on the right-hand side of the rudder, which moves the plane's nose to the left.

You might be interested in

What is the mass of air in a room

Karo-lina-s [1.5K]

Answer:

Just do 1000 times 1.8

Explanation:

This is a good answer

7 0

3 years ago

A farmers field , which are close to a stream has experienced a lot of runoff. One possible effect of the run off is that the st

Vladimir79 [104]

Answer:

This statement is false.

Explanation:

If the farmers field is close to the stream, and has experienced a lot of runoff, the runoff will carry chemicals from the farm into the stream, which includes fertilizers among other chemicals. This runoff into the stream will not lead to a decrease in the level of fertilizers in the stream. Therefore, one of the effect of this cannot be a decrease in the level of fertilizers from the field.

6 0

3 years ago

Choose all correct sentences a. The power (equation 8) is maximum when the value of the impedance is greater than the value of t

konstantin123 [22]

Answer:

Note: Check the attached image for a clearer question

From the attached image, the answers are 2,3,6,7

Explanation:

Maximum power occurs at resonance, i.e. $X_{L} = X_{C}$ , not when impedance is greater than resistance

Resonance occurs when the Inductive reactance equals the capacitive reactance, i.e. $X_{L} = X_{C}$ , not $R^{2} = (X_{L} - X_{C} ) ^{2}$

and when, $w = \frac{1}{\sqrt{LC} }$

Therefore, option B is correct

Since the formula for impedance is $Z = \sqrt{R^{2} + (X_{L}-X_{C}) ^{2} }$ , at resonance, Z = R i.e. the impedance is minimum

At resonance, there is maximum power and minimum impedance

Thew Quality Factor, $Q = \frac{w_{0}L }{R} = \frac{1}{R} \sqrt{\frac{L}{C} }$

The impedance Z is always larger than the resistance R, note that it is not stated that this condition is at Resonance, that makes it correct.

$Z = \sqrt{R^{2} + X^{2} }$

4 0

3 years ago

Consider layers of three media of different index of refraction. The thickness of layers is the same, say L. Medium A has index

tatiyna

Answer:

Medium A -> medium C -> medium B

Explanation:

Refraction is defined a s the change in the direction of light rays as it moves from one medium to another. The speed of the light in this media depends on the nature and the refractive indices of the media.

Light has the tendency to travel faster through a medium with low refractive index rather than high refractive index.

Comparing this medias based on the above conclusion

Medium A has index of refraction 1.3; medium

B has index of refraction 1.4 and medium

C has index of refraction 1.35

The light will travel faster in medium A since it have the lowest refractive index followed by medium C then medium B.

Ranking of the media in accordance the time it takes for light to travel through these layers are as shown

Medium A -> medium C -> medium B

3 0

3 years ago

Determine which heat transfers below are due to the process of conduction. I) You walk barefoot on the hot street and it burns y

Taya2010 [7]

Answer:

I) You walk barefoot on the hot street and it burns your toes.

II) When you get into a car with hot black leather in the middle of the summer and your skin starts to get burned.

Explanation:

In conduction mode of heat transfer we know that the energy is transferred from one system to other system due to direct contact of two bodies

Here due to this direct contact the energy is transferred via a given solid or liquid medium

In this type of heat transfer medium particles will remain in its own position only the energy is transferred.

So here we can say the correct answer will be

I) You walk barefoot on the hot street and it burns your toes.

II) When you get into a car with hot black leather in the middle of the summer and your skin starts to get burned.

3 0

4 years ago