All categories

3 years ago

Why is sand used as a bed for melting of metal in Cupola furnace?

Engineering

1 answer:

siniylev [52]3 years ago

5 0

Answer:

A sand bed is necessary because it provides a refractory bottom for molten metal

You might be interested in

4.68 Steam enters a turbine in a vapor power plant operating at steady state at 560°C, 80 bar, and exits as a saturated vapor at

garik1379 [7]

Answer:

please mark me as a brainleast

Explanation:

hahahahhahaahhahahahahahahahahahahahahahahahaahhhahhhahaahahhaahhhahahaah

3 0

3 years ago

How can any student outside apply for studying engineering at Cambridge University

telo118 [61]

Admission to the Engineering course at Cambridge is highly competitive, both in terms of the numbers and quality of applicants. In considering applicants, Colleges look for evidence both of academic ability and of motivation towards Engineering. There are no absolute standards required of A Level achievement, but it should be noted that the average entrant to the Department has three A* grades. You need to get top marks in Maths and Physics.All Colleges strongly prefer applicants for Engineering to be taking a third subject that is relevant to Engineering.
Hope that helps and good luck if you are applying. Can you please mark this as brainliest and press the thank you button and if you have any further questions please let me know!!

3 0

3 years ago

Steam enters an adiabatic turbine at 8 MPa and 500C with a mass flow rate of 3

Vinil7 [7]

Answer:

a)temperature=69.1C

b)3054Kw

Explanation:

Hello!

To solve this problem follow the steps below, the complete procedure is in the attached image

1. draw a complete outline of the problem

2. to find the temperature at the turbine exit use termodinamic tables to find the saturation temperature at 30kPa

note=Through laboratory tests, thermodynamic tables were developed, these allow to know all the thermodynamic properties of a substance (entropy, enthalpy, pressure, specific volume, internal energy etc ..)

through prior knowledge of two other properties such as pressure and temperature.

3. Using thermodynamic tables find the enthalpy and entropy at the turbine inlet, then find the ideal enthalpy using the entropy of state 1 and the outlet pressure = 30kPa

4. The efficiency of the turbine is defined as the ratio between the real power and the ideal power, with this we find the real enthalpy.

Note: Remember that for a turbine with a single input and output, the power is calculated as the product of the mass flow and the difference in enthalpies.

5. Find the real power of the turbine

3 0

3 years ago

Which statements describe the motion of car A and car B? Check all that apply. Car A and car B are both moving toward the origin

vekshin1

Answer:

car a is moving faster than the car b

8 0

3 years ago

What is the composition, in atom percent, of an alloy that consists of 4.5 wt% Pb and 95.5 wt% Sn?

jeka57 [31]

Answer: Option A is correct -- 2.6 at% Pb and 97.4 at% Sn.

Explanation:

Option A is the only correct option -- 2.6 at% Pb and 97.4 at% Sn. While option B, which is 7.6 at% Pb and 92.4 at% Sn. and option C, which is 97.4 at% Pb and 2.6 at% Sn. and option D, which is 92.4 at% Pb and 7.6 at% Sn. are wrong.

6 0

4 years ago