1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
kirill [66]
2 years ago
6

Someone tell me the answer plz!!DONT be rude and just answer for points:)

Engineering
2 answers:
Sergeeva-Olga [200]2 years ago
4 0
I think is letter B
Vedmedyk [2.9K]2 years ago
3 0

Answer:

B

Explanation:

B

You might be interested in
What are the optical properties of steel
dezoksy [38]

Answer:

A selective surface with large absorption for solar radiation and high reflectance for thermal infrared radiation was produced by use of surface oxidation of stainless steel. The surfaces were studied for use with concentrated light in a solar power plant at temperatures of 400°C and higher.

In order to investigate the relation between surface treatment and optical properties, stainless steels (AISI 304 and 430) which were submitted to different chemical and mechanical surface treatments, were used. To increase the spectral selectivity, these surfaces were treated in air and in vacuum at different temperatures and times. The optical properties of these films were investigated. Visual and infrared spectral absorptances were measured at room temperature. The thermal hemispherical emittance and absorptance were obtained by a calorimetric method at 200°C. It was noticed that these chemically and mechanically treated stainless steel surfaces have good spectral properties without further oxidations. This is very important for high temperature uses. The best values are found for samples 7 and 8 under vacuum and air. These two samples with mechanically ground surfaces retained their selectivity and specularity after several hours oxidation. One can conclude that the surface ground treatment confers good selectivity on the steel surfaces for use in concentrating solar collectors with a working temperature of 500°C.

Sample surfaces were subjected to long temperature ageing tests in order to gain some idea of the thermal stability of the surfaces. The results promise better-performing surface and the production of durable selective finishes at, possibly, lower cost than competing processes.

Explanation:

3 0
3 years ago
A smooth concrete pipe (1.5-ft diameter) carries water from a reservoir to an industrial treatment plant 1 mile away and dischar
Kamila [148]

ANSWER:

Q = 0.17ft3/s

EXPLANATION: since the water runs downhill on a 1:100 slope, that means the flow is laminar.

Using poiseuille equation:

Q = (π × D^4 × ∆P) ÷ (128 × U × ∆X)

Q is the volume flow rate.

π is pie constant value at 3.142

D is the diameter of the pipe

∆P is the pressure drop

U is the viscosity

∆X is the length of the pipe or distance of flow.

Form the question, we are to determine U then Find Q

Therefore;

D = 1.5ft

∆P = 1pa since the minor losses are negligible.

∆X = 1mile = 5280ft.

STEP1: FIND U

Viscosity is a function of the temperature of the liquid. An increase in temperature increases the viscosity of the liquid.

We know that at room temperature, which is 25°C the viscosity of water is 8.9×10^-4pa.s . We can find the viscosity of water at 4°C by cross multiplying.

Therefore;

25°C = 8.9×10^-4pa.s

4°C = U

Cross multiply

U25°C = 4°C × 8.9×10^-4pa.s

U25°C = 0.00356°C.pa.s

Therefore;

U = 0.00356°C.pa.s ÷ 25°C

U = 1.424×10^-4pa.s

Therefore at 4°C the viscosity of water in the pipe is 1.424×10^-4pa.s

STEP2: FIND Q

Imputing the values into poiseuille equation above.

Q = (3.142 × (1.5ft)^4 × 1pa) ÷ (128 × 1.424×10^-4pa.s × 5280ft)

Q = 15.906375pa.ft4 ÷ 96.239616pa.s.ft

Therefore;

Q = 0.16547887ft3/s

Approximately;

Q = 0.17ft3/s

6 0
3 years ago
stimate the maximum efficiency of an automobile engine that has a compression ratio of 5:1.0. Assume the engine operates accordi
Fed [463]

Answer:

Efficiency based on Otto cycle.

Effotto = 47.47%

Explanation:

Efficiency based on Otto cycle.

effotto = 1 – (V2 / V1)^γ-1

effotto = 1 – (1 / 5)^1.4 - 1

effotto = 47.47%

5 0
3 years ago
Draw perpendicular lines based on the info in the image.
Over [174]
Wait let me try it…..
5 0
3 years ago
A gas expands in a piston-cylinder assembly from p1 = 8 bar, V1 = 0.02 m3 to p2 = 2 bar. The relation between pressure and volum
Charra [1.4K]

Answer:

The heat transfer is 29.75 kJ

Explanation:

The process is a polytropic expansion process

General polytropic expansion process is given by PV^n = constant

Comparing PV^n = constant with PV^1.2 = constant

n = 1.2

(V2/V1)^n = P1/P2

(V2/0.02)^1.2 = 8/2

V2/0.02 = 4^(1/1.2)

V2 = 0.02 × 3.2 = 0.064 m^3

W = (P2V2 - P1V1)/1-n

P1 = 8 bar = 8×100 = 800 kPa

P2 = 2 bar = 2×100 = 200 kPa

V1 = 0.02 m^3

V2 = 0.064 m^3

1 - n = 1 - 1.2 = -0.2

W = (200×0.064 - 800×0.02)/-0.2 = -3.2/-0.2 = 16 kJ

∆U = 55 kJ/kg × 0.25 kg = 13.75 kJ

Heat transfer (Q) = ∆U + W = 13.75 + 16 = 29.75 kJ

7 0
3 years ago
Other questions:
  • What is something that a robot or computer program might do that requires a decision, or conditional statement?
    9·1 answer
  • "Write a statement that outputs variable numItems. End with a newline. Program will be tested with different input values."
    15·1 answer
  • The cross-section of a rough, rectangular, concrete() channel measures . The channel slope is 0.02ft/ft. Using the Darcy-Weisbac
    8·1 answer
  • A car is traveling at 50 ft/s when the driver notices a stop sign 100 ft ahead and steps on the brake. Assuming that the deceler
    6·1 answer
  • Which of the following is part of the highway
    11·2 answers
  • Piping layout carrying liquid water at 70°F at a volumetric flow rate of 0.2 is composed of four sections of 4-in. Diameter stee
    12·1 answer
  • What is a combination circuit? A combination circuit:
    6·1 answer
  • Which of the following is not caused by alcohol?
    10·2 answers
  • For many clients, a decision is based primarily on time and money, which are the two most abundant
    10·2 answers
  • By adding "-once", one can form the noun form of the word "organize" is that true or false?​
    5·2 answers
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!