Answer:
Explanation:
Given that
Load is uniformly distributed load and beam is simply supported.
Ra + Rb= wL
Ra = Rb =wL / 2
Lets x is measured from left side,then the deflection of beam at any distance x is given as
The maximum deflection of beam will at x = L/2 (mid point )
Wooden 2 X 8's, 10's, or 12's that run parallel to one another and support a floor or ceiling, and supported in turn by larger beams, girders, or bearing walls- <u>Joist</u>
Explanation:
- Wooden 2 X 8's, 10's, or 12's that run parallel to one another and support a floor or ceiling, and supported in turn by larger beams, girders, or bearing walls- <u>Joist</u>
- A point where a bearing/structural weight is concentrated and transferred to the foundation-<u>Point Load</u>
- Includes all exterior walls and any interior wall that is aligned above a support beam or girder-<u>Load Bearing Wall</u>
- Plywood substitute made of coarse sawdust that is mixed with resin and pressed into sheets-<u>Particleboard</u>
- The replacement of excavated earth into a trench around or against a basement/crawl space foundation wall- <u>Backfill</u>
- Continuous 8m" or 10" thick concrete pad installed before and supports the foundation wall or monopost-<u>Footing</u>
- Ribbed steel bars installed in foundation concrete walls, footers and poured in place concrete structures designed to strengthen concrete-<u>Rebar</u>
- The end, upper, triangular area of a home, beneath the roof-<u>Gable</u>
- A manufactured 4X8 wood panel made out of 1-2 wood chips and glue. Often used as a substitute for plywood-<u>OSB</u>
- The incline slope of a roof or the ratio of the total width of a house-<u>Pitch</u>
- A manufactured structual wood beam. It is constructed of pressure and adhesive wood strands of wood-<u>Microlam</u>
Answer:
The pouring of the molten metal during casting is done very slowly hence the molten metal froze before reaching all parts of the mould cavity. also the early freezing can occur if the temperature of the molten metal was lower than the required temperature for casting
Explanation:
since the same components are being casted at other foundries and they don't have the defects ,
Hence the reason for the defects experienced by these components can be caused when the pouring of the molten metal during casting is done very slowly hence the molten metal froze before reaching all parts of the mould cavity. also the early freezing can occur if the temperature of the molten metal was lower than the required temperature for casting .
Answer:
The high conversion in a CSTR with not very well mixing occurs mostly if the reactor is micro reactor.
From Literature, mixing due to diffusion depends on concentration or temperature gradients. This is commonly represented in micro reactors.
Also, the residence time distribution (RTD) Analysis provides information on how long the various components of fluid have been in the reactor which leads to more conversion in some cases of fluid reaction.
Answer:
Check the Attached Image
Explanation:
The full solution is in the attached image below