Answer:
Explanation:
Fist you need to identify where the leak is coming from. You can do this by either listening for the leak or spraying soapy water on the exhaust to look for air bubbles coming out of the exhaust. Depending on the spot of the leak there are many ways you can fix this leak.
1. Exhaust clamp
2. Exhaust putty
3. Exhaust tape
4. New exhaust
Exhaust clamp is best used for holes on straight pipes.
Putty is best used on welds or small holes like on exhaust manifolds or welds connecting various pieces like catalytic converters, mufflers, or resonators.
Tape will work best on straight pipes with holes.
New exhaust is for when the thig is beyond repair, like rust.
Now good luck because working on exhausts is a pain.
Answer:
Ammeters must always be connected in series with the circuit under test. Always start with the highest range of an ammeter. Deenergize and discharge the circuit completely before you connect or disconnect the ammeter. In dc ammeters, observe the proper circuit polarity to prevent the meter from being damaged.
Explanation:
Answer: Dash light
Explanation:
A dash light, usually labeled "BRAKE" will illuminated if a braking system fails, or if the brake fluid is low.
Answer:
try to pop it back in good luck im scared for you
