Answer:
Deposition
Explanation:
- Deposition occurs when water slows or ceases moving, the wind dies or stops blowing, or glaciers melt. The deposited material can also be used to construct new landforms. Waves, for example, can dump sediment in places offshore, where it might accumulate to form sand dunes.
When the wind calms down or vegetation stops or slows the breeze, the sediment particles begin to fall. Water is another factor that may erode, move, or deposit sediment. Flowing water is a key erosive agent. Water transports dirt and rock fragments as it moves. Warm, wet air will not travel if wind systems are not present. Water will still evaporate, but it will not move, therefore everywhere else than a major body of water will dry up. Lakes may be fine since evaporating water will flow back into them, and the sea will be fine, but everywhere else will become extremely dry very rapidly. Wind is constantly blowing somewhere on the world at any given time. Winds are usually quiet near the middle of a high pressure system. Wind is the passage of air from a high pressure location to a low pressure area.... So essentially air is always moving. Weathering and erosion are caused by wind. Weathering is caused by wind blowing debris against cliffs and huge rocks. This wears down the rock, reducing it to sand and dust. Sand and dust are also eroded by wind. 2. Rocks are tough and durable, but they don't last forever. Weathering and erosion are processes that occur as a result of forces such as wind and water breaking down rocks. Weathering is the process through which rocks deteriorate. Weathering is caused by a variety of factors, including climate change.
Answer:
The flow of energy from falling water to the steam is;
a) Mechanical → Mechanical → Electrical → Thermal → Thermal
Explanation:
1) Mechanical → Mechanical
The water in the pipe before it falls possesses potential energy which it converts into kinetic energy as it falls from height
2) Mechanical → Mechanical
The water falling from the pipe stream unto the turbine wheel transfers its kinetic (mechanical) energy due to its motion on to the turbine wheel to give the wheel rotational motion
3) Mechanical → Electrical
The kinetic (mechanical) energy from the rotating turbine wheel is converted into electrical energy in the electrical generator which transported through the electrical circuit
4) Electrical → Thermal
The electrical energy from the electric current is then converted into thermal energy as the current passes through the resistors in the heating filament
5) Thermal → Thermal
The heated filament transfers thermal energy to the the water in the beaker by conduction which raises the temperature of the water such that as the water acquires more thermal energy it turns into steam
Therefore, we have the flow of energy from the falling water to steam as follows;
1) Mechanical 2) Mechanical 3) Electrical 4) Thermal 5) Thermal
If u mean black hole*
It’s a space where gravity pulls so much that even light can not get out. The gravity is so strong because matter has been squeezed into a tiny space. This can happen when a star is dying because no light can get out, people can’t see black holes. They are invisible.
Black holes of stellar mass form when very massive starts collapse at the end of their life cycle.
- info from NASA
Answer:
Point charge will be equal to
Explanation:
We have given distance of A from point charge
Distance of point B from point charge
We know that potential difference due to point charge is given as
So potential difference at point A
And potential difference at point B
We have given
So
So point charge will be equal to