All categories

3 years ago

People working in the maintenance, installation and repair pathway work from home.

Engineering

2 answers:

Lerok [7]3 years ago

8 0

people working in the maintenance, installation and repair pathway work from home.

b) false

denpristay [2]3 years ago

4 0

The answer is false as the maintenance is correct

You might be interested in

B1) 20 pts. The thickness of each of the two sheets to be resistance spot welded is 3.5 mm. It is desired to form a weld nugget

kap26 [50]

Answer:

minimum current level required = 8975.95 amperes

Explanation:

Given data:

diameter = 5.5 mm

length = 5.0 mm

T = 0.3

unit melting energy = 9.5 j/mm^3

electrical resistance = 140 micro ohms

thickness of each of the two sheets = 3.5mm

Determine the minimum current level required

first we calculate the volume of the weld nugget

v = $\frac{\pi }{4} * D^2 * l$ = $\frac{\pi }{4} * 5.5^2 * 5$ = 118.73 mm^3

next calculate the required melting energy

= volume of weld nugget * unit melting energy

= 118.73 * 9.5 = 1127.94 joules

next find the actual required electric energy

= required melting energy / efficiency

= 1127 .94 / ( 1/3 ) = 3383.84 J

TO DETERMINE THE CURRENT LEVEL REQUIRED use the relation below

electrical energy = I^2 * R * T

3383.84 / R*T = I^2

3383.84 / (( 140 * 10^-6 ) * 0.3 ) = I^2

therefore 8975.95 = I ( current )

4 0

4 years ago

g A pump is required to deliver 100 gpm at a head of 100 ft, but the pump rated capacity is 150 gpm at a head of 100 ft. If the

Thepotemich [5.8K]

Answer: valving the pump discharge to reduce the flow will only result in an increase in the water velocity according to the laws of continuity of flow.

Q = AV = constant.

The pump speed of 150 gpm is, and will remain constant. Valving simply reduces flow area A, which is balanced out by increased velocity V of water through the pipe.

This does not affect the pump speed Q (flow rate) and hence it remains the same.

8 0

3 years ago

Just need someone to talk to pls dont just use me for points

Allushta [10]

Answer:

well what do you wanna talk about friend?

Explanation:

7 0

3 years ago

The angle of twist can be computed using the material’s shear modulus if and only if: (a)- The shear stress is still in the elas

ollegr [7]

Answer:

The angle of twist can be computed using the material’s shear modulus if and only if the shear stress is still in the elastic region

Explanation:

The shear modulus (G) is the ratio of shear stress to shear strain. Like the modulus of elasticity, the shear modulus is governed by Hooke’s Law: the relationship between shear stress and shear strain is proportional up to the proportional limit of the material. The angle of twist can be computed using the material’s shear modulus if and only if the shear stress is still in the elastic region.

3 0

4 years ago

Liquid benzene and liquid n-hexane are blended to form a stream flowing at a rate of 1700 lbm/h. An on-line densitometer (an ins

Taya2010 [7]

Let me think of that

5 0

3 years ago