Answer:
Sound quality depends on a lot of factors, and it is impossible to definitively state that either analog or digital is fundamentally better. These days, many records are made using playback of a digital file, so vinyl preference cannot be attributed solely to the differences in the way the sound wave is reproduced.
Explanation:
Answer:
Explanation:
wave length of light λ = 502 nm
screen distance D = 1.2 m
width of one fringe = 10.2 mm / 20
= .51 mm
fringe width = λ D / a , a is separation of slits
Puting the values given
.51 x 10⁻³ = 502 x 10⁻⁹ x 1.2 / a
a = 502 x 10⁻⁹ x 1.2 / .51 x 10⁻³
= 1181.17 x 10⁻⁶ m
1.18 x 10⁻³ m
= 1.18 mm .
Answer:
a) 
b) This value of specific heat is close to the specific heat of ice at -40° C and the specific heat of peat (a variety of coal).
c) The material is peat, possibly.
d) The material cannot be ice because ice doesn't exists at a temperature of 100°C.
Explanation:
Given:
- mass of aluminium,

- mass of water,

- initial temperature of the system,

- mass of copper block,

- temperature of copper block,

- mass of the other block,

- temperature of the other block,

- final equilibrium temperature,

We have,
specific heat of aluminium, 
specific heat of copper, 
specific heat of water, 
Using the heat energy conservation equation.
The heat absorbed by the system of the calorie-meter to reach the final temperature.



The heat released by the blocks when dipped into water:

where
specific heat of the unknown material
For the conservation of energy : 
so,


b)
This value of specific heat is close to the specific heat of ice at -40° C and the specific heat of peat (a variety of coal).
c)
The material is peat, possibly.
d)
The material cannot be ice because ice doesn't exists at a temperature of 100°C.
Frequency is measured in units of reciprocal time.
Period is measured in units of time.
Phase is a number without units that represents a fraction of a wave.
None of these is measured in meters, so none of them can be the answer.
It must be either amplitude or wavelength.
Amplitude is a quantity that's measured at one or two points in the same wave.
The question is talking about points on consecutive waves.
<em>Wavelength is</em> the only choice left. That must be it.
Answer:
96%
Explanation:
To find the values of the motor efficiency you use the following formula:

P_o: output power = 864J/0.5min=864J/30s=28.8W
P_i: input power = I*V = (3A)(12V) = 36W
By replacing this values you obtain:

hence, the motor efficiency is about 96%
traslation:
Pentru a găsi valorile eficienței motorului, utilizați următoarea formulă:
P_o: putere de ieșire = 864J / 0.5min = 864J / 30s = 28.8W
P_i: putere de intrare = I * V = (3A) (12V) = 36W
Înlocuind aceste valori obțineți:
prin urmare, eficiența motorului este de aproximativ 96%