All categories

2 years ago

It was determined by the forensic engineers that the historic collapse of the Minneapolis Interstate Bridge was due to

1 answer:

4 0

It was determined by the forensic engineers that the historic collapse of the Minneapolis Interstate Bridge was due to design and construction flaws. It led to the collapse of the structure.

<h3>What is the Minneapolis Interstate Bridge?</h3>

The Minneapolis Interstate Bridge is a well-known bridge that was constructed in Minneapolis city in 1967.

It has been demonstrated that the collapse of this bridge constructed in Minneapolis was due to its inadequate load capacity.

In architecture, it is fundamental to measure the amount of weight that a structure (in this case, a bridge) can sustain in a given period of time.

Learn more about the bridge construction here:

brainly.com/question/24686952

You might be interested in

Examine a process whereby air at 300 K, 100 kPa is compressed in a piston/cylinder arrangement to 600 kPa. Assume the process is

professor190 [17]

Answer:

See attachment and explanation.

Explanation:

- The following question can be solved better with the help of a MATLAB program as follows. The code is given in the attachment.

- The plot of the graph is given in attachment.

- The code covers the entire spectrum of the poly-tropic range ( 1.2 - 1.6 ) and 20 steps ( cases ) have been plotted and compared in the attached plot.

3 0

3 years ago

6. Driving with parking lights only (in place of headlights) is against the law. A. True B. False

trasher [3.6K]

Answer:

B false it is illegal to only have got fog lights on though and bright headlights because it can distract other drivers going last and if the y are distracted then that will cause a collision

Hope this helps :)

Explanation:

4 0

3 years ago

Read 2 more answers

14. The top plate of the bearing partition

aliina [53]

Answer:

d. is applied after the ceiling joists are

installed.

7 0

3 years ago

A 600-MW steam power plant, which is cooled by a nearby river, has a thermal efficiency of 54 percent. Determine the rate of hea

Gennadij [26K]

Answer:

$\dot Q _{L} = 511.111 MW$ . Heat transfer can be higher if themal efficiency is lower.

Explanation:

The heat transfer rate to the river water is calculated by this expression:

$\dot Q_{L} = \dot Q_{H} - \dot W$

$\dot Q_{L} = (\frac{1}{\eta_{th}}-1 )\cdot \dot W\\\dot Q_{L} = (\frac{1}{0.54}-1)\cdot (600 MW)\\\dot Q _{L} = 511.111 MW$

The actual heat transfer can be higher if the steam power plant reports an thermal efficiency lower than expected.

8 0

3 years ago

Technician A says that a way to prevent galvanic corrosion is to duplicate the original installation method. Technician B says t

sertanlavr [38]

Answer:

Technician A

Explanation:

Galvanic corrosion is not on only one metal alone but caused when two metals are interacting. Thus, Duplicating the original installation method is a better option because re-using a coated bolt doesn't prevent galvanic corrosion because both materials must be coated and not just the bolt and in technician B's case he is coating just the bolt. Thus, technician B's method will not achieve prevention of galvanic corrosion but technician A's method will achieve it.

8 0

2 years ago