Temperature is a measure of the energy of molecules and energy is related to speed.
<span>The water in a pot is heated by convection. The water on the bottom will warm up and rise toward the surface and the cooler water will then sink to the bottom where it will be heated. </span>
<span>Oxygen will form ionic bonds with nitrogen. The others will not by themselves. </span>
<span>A high pH is indicative of a basic solution. HCl and H2SO4 are both strong acids and will result in a lower (more acidic) pH. Water is the standard. KOH is a strong base and will increase the pH. </span>
<span>An acidic solid will lower the pH of a solution. pH measures the number of hydrogen ions and a lower pH will mean that there are more H+ ions, but the solid could just have reacted with the OH- to cause the pH to decrease</span>
A scientist would write that number as 1.49 x 10⁸ kilometers .
(Or, if the scientist is in France or the UK, he might write it as 1.49 x 10⁸ kilometres .)
Answer:
In fact, carving letters into a tree probably won't hurt it. ... In general, the tree will compartmentalize the wound and it will heal over. The initials that remain visible are essentially scar tissue, permanent scar tissue.
Explanation:
Unfortunately, when carving into the trunk of a tree the blade of a knife often penetrates the outer bark and cuts into the inner bark. ... In cases that the phloem is damaged all the way around the trunk (in a ring for example), the tree will slowly and eventually starve to death.
add my s n a p
luke_raines19
If you have no idea what the voltage is that you're about to measure,
then you should set the meter to the highest range before you connect
it to the two points in the circuit.
Analog meters indicate the measurement by moving a physical needle
across a physical card with physical numbers printed on it. If the unknown
voltage happens to be 100 times the full range to which the meter is set,
then the needle may find itself trying to move to a position that's 100 times
past the highest number on the meter's face. You'll hear a soft 'twang',
followed by a louder 'CLICK'. Then you'll wonder why the meter has no
needle on it, and then you'll walk over to the other side of the room and
pick up the needle off the floor, and then you'll probably put the needle
in your pocket. That will end your voltage measurements for that day,
and certainly for that meter.
Been there.
Done that.
