Answer:
For Figure Below, if the elevation of the benchmark A is 25.00 m above MSL:
1. Using the Rise and Fall Method, find the reduced level for all points. (Construct the Table)
2. Using HPC Method, find the reduced level for all points. ( Construct the Table).
3. Show all required Arithmetic checks for your work. For Item 1 and 2.
4. What is the difference in height between points H and D?
5. What is the gradient of the line connecting A and J, knowing that horizontal distance = 200
m.
Answer:
mark brainliest :)
Explanation:
Injection Molding. Injection molding is the most commonly used manufacturing process for the fabrication of plastic parts. ... The plastic is melted in the injection molding machine and then injected into the mold, where it cools and solidifies into the final part.
Materials: Thermoplastics
Answer:
Technician B
Explanation:
Resistance, 
where V is the voltage and I is the current in amps
Therefore, 
Power=VI=12*12=144 W
Therefore, the power is 144 W and resistance is 1 Ohm. This implies that technician A is wrong while technician B is correct
Answer:
i don't think i understand the question
Explanation:
Answer:
correct option is (A) 0.5
Explanation:
given data
axial column load = 250 kN per meter
footing placed = 0.5 m
cohesion = 25 kPa
internal friction angle = 5°
solution
we know angle of internal friction is 5° that is near to 0°
so it means the soil is almost cohesive soil.
and for a pure cohesive soil
= 0
and we know formula for is
= (Nq - 1 ) × tan(Ф) ..................1
so here Ф is very less should be nearest to zero
and its value can be 0.5
so correct option is (A) 0.5
