Answer:
P.E.T
Explanation:
Stud is a short form of stud wall which are typically vertical framing members in a wall of a building. Wall studs are available in standard lengths but since the height of ceiling vary, sometimes one has to cut the stud walls on site to fit. Therefore, there are pre-cut studs which are more efficient in implementation. These are usually referred as Precision-End Trimmed studs, (P.E.T). Therefore, stud walls which are cut to exact length at the mill for modern construction are designated by letters P.E.T
Answer:
1.176
Explanation:
When the bullets impact the mass they become embedded on it, it is a plastic collision, therefore momentum is conserved.
v2 * (M + mb) = v1 * mb
Where
v1: muzzle velocity of the bullet
M: mass of the bob
mb: mass of the bullet
v2: mass of the bob with the bullet after being hit
v2 = v1 * mb / (M + mb)
Upon being impacted the bob will acquire speed v2, this implies a kinetic energy. The bob will then move and raise a height h. Upon acheiving the maximum height it will have a speed of zero. At that point all kinetic energy will be converted into potential energy.
Ek = 1/2 (M + mb) * v2^2
Ep = (M + mb) * g * h
Ek = Ep
1/2 (M + mb) * v2^2 = (M + mb) * g * h
1/2 * (v1 * mb / (M + mb))^2 = g * h
1/2 * v1^2 * mb^2 / (M + mb)^2 = g * h
v1^2 = g *h * (M+ mb)^2 / (1/2 * mb^2)

The height h that it reaches is related to the length L of the pendulum arm and the angle it forms with the vertical.
h = L * (1 - cos(a))

For the 9 mm:

For the 0.44 caliber:

The ratio is 460 / 391 = 1.176
Answer:
import java.util.Scanner;
public class SumVectorElements
{
public static void main(String[] args)
{
final int NUM_VALS = 4;
int[] origList = new int[NUM_VALS];
int[] offsetAmount = new int[NUM_VALS];
int i = 0;
origList[0] = 40;
origList[1] = 50;
origList[2] = 60;
origList[3] = 70;
offsetAmount[0] = 5;
offsetAmount[1] = 7;
offsetAmount[2] = 3;
offsetAmount[3] = 0;
/* Your solution goes here */
// Print the Sum of each element in the origList
// with the corresponding value in the
// offsetAmount.
for (i = 0; i < NUM_VALS; i++)
{
System.out.print((origList[i] + offsetAmount[i])+" ");
}
System.out.println("");
return;
}
}
Explanation: see attachment below
Answer:
Technician B only is correct
Explanation:
Voltage drop testing is a method used to find the amount of electrical resistance available in an high amperage circuit that involves connecting the leads of the meter in parallel to the circuits being tested such that disassembly is not required
In voltage drop test, the red voltmeter lead and black voltmeter lead are placed at two points on the same side of the circuit connection such that the leads are in between two positive connection or two negative connection (rather than connecting the red to the positive and the black to the negative sides of the circuit) and digital voltmeter is used for the voltage drop measurement across the lead while the connection is under load.
Therefore, Technician B only is correct