All categories

3 years ago

Which is always needed to change an object’s state of motion?

1 answer:

azamat3 years ago

8 0

Newton's first law of motion is sometimes called the law of inertia. When the forces acting on an object are balanced, the object is either at rest or moving with a constant velocity. Unbalanced forces can cause an object to accelerate or decelerate. Unbalanced forces can also cause an object to change direction.

You might be interested in

A thin Nichrome wire connected to an ammeter surrounds a region of time-varying magnetic flux, and the ammeter reads 13 amperes.

Semenov [28]

Answer:

The current would be same in both situation.

Explanation:

Given that,

Current I = 13 A

Number of turns = 23

We need to calculate the induced emf

Using formula of induced emf is

$\epsilon=NA\dfrac{dB}{dt}$

For N = 1

$\epsilon=A\dfrac{dB}{dt}$

We need to calculate the current

Using formula of current

$i=\dfrac{\epsilon}{R}$

Put the value of emf

$i=\dfrac{A\dfrac{dB}{dt}}{R}$

Now, if the number of turn is 22 , then induced emf would be

$\epsilon'=NA\dfrac{dB}{dt}$

Then the current would be

$i'=\dfrac{\epsilon'}{NR}$

$i'=\dfrac{NA\dfrac{dB}{dt}}{NR}$

$i'=\dfrac{A\dfrac{dB}{dt}}{R}$

$i'=i$

Hence, The current would be same in both situation.

4 0

4 years ago

The perceived loudness of a sound is measured in

diamong [38]

<h2>Answer: decibels </h2>

The decibel $dB$ is the relation between two values: the pressure produced by a sound wave and a pressure taken as a reference. Resulting in a dimensionless value.

It should be noted that itself<u> is not a unit of measure</u>, since in reality the unit is bel $B$ (which <u>is not part of the International System of Units</u>) in honor of Alexander Graham Bell.

However, given the amplitude of the measured elements in practice, its submultiple, the decibel, is used. That is, this quotient is a logarithmic expression, where $1dB=0.1B$

5 0

3 years ago

A cannon is fired straight up into the air. If the cannon ball comes back down to the launch point in 5 seconds, what was the ma

Nana76 [90]

Answer:

30.63 m

Explanation:

From the question given above, the following data were obtained:

Total time (T) spent by the ball in air = 5 s

Maximum height (h) =.?

Next, we shall determine the time taken to reach the maximum height. This can be obtained as follow:

Total time (T) spent by the ball in air = 5 s

Time (t) taken to reach the maximum height =.?

T = 2t

5 = 2t

Divide both side by 2

t = 5/2

t = 2.5 s

Thus, the time (t) taken to reach the maximum height is 2.5 s

Finally, we shall determine the maximum height reached by the ball as follow:

Time (t) taken to reach the maximum height = 2.5 s

Acceleration due to gravity (g) = 9.8 m/s²

Maximum height (h) =.?

h = ½gt²

h = ½ × 9.8 × 2.5²

h = 4.9 × 6.25

h = 30.625 ≈ 30.63 m

Therefore, the maximum height reached by the cannon ball is 30.63 m

3 0

4 years ago

A piece of wood is floating in a bathtub. A second piece of wood sits on top of the first piece, and does not touch the water. I

Mashutka [201]

Answer:

the water level remains same

Explanation:

This can be explained by Archimedes's principle which says that the wood will sink if weight of wood is more than the weight of the water displaced with weight equal to the water displaced otherwise the wood will float.

Therefore, buoyancy or the buoyant force is the same as the weight of wood, the weight of the water displaced by wood is also the same as that of the weight of wood.

Thus, we can see that the weight of the wood remains same and so is the level of water.

6 0

3 years ago

Why are there only two elements in the first period of the periodic table?(1 point)

Katen [24]

Answer:

because only two electrons can fit in the first orbit around the nucleus, and each period on the table is organized by number of orbits

6 0

3 years ago