Answer:
Explanation:
Hello.
In this case, since the velocity is computed via the division of the distance traveled by the elapsed time:
The distance is clearly 1743 km and the time is:
Thus, the velocity turns out:
Which is a typical velocity for a plane to allow it be stable when flying.
Best regards.
<em>Labels that belong in the marked ares X, Y & Z include;</em>
X: Curves outward
Y: Image may be smaller than object
Z: Image is always virtual
<u>Since the rays never meet, the images formed by convex mirrors are always virtual and smaller than the object, and since they are smaller, the images appear to be further than they actually are.</u>
The stopwatch will be the most useful in determining the kinetic energy of a 50 g battery- powered car traveling a distance of 10 m.
<h3>What is kinetic energy?</h3>
Kinetic energy is the energy of a body possessed due to motion.
This means that for an object to possess kinetic energy, it must be in motion.
The kinetic energy is measured in Joules, which is a product of the mass of the substance and the time taken to travel a distance.
A stopwatch is an instrument used to measure time as one of the components of kinetic energy.
Therefore, the stopwatch will be the most useful in determining the kinetic energy of a 50 g battery- powered car traveling a distance of 10 m.
Learn more about kinetic energy at: brainly.com/question/12669551
If you have no idea what the voltage is that you're about to measure,
then you should set the meter to the highest range before you connect
it to the two points in the circuit.
Analog meters indicate the measurement by moving a physical needle
across a physical card with physical numbers printed on it. If the unknown
voltage happens to be 100 times the full range to which the meter is set,
then the needle may find itself trying to move to a position that's 100 times
past the highest number on the meter's face. You'll hear a soft 'twang',
followed by a louder 'CLICK'. Then you'll wonder why the meter has no
needle on it, and then you'll walk over to the other side of the room and
pick up the needle off the floor, and then you'll probably put the needle
in your pocket. That will end your voltage measurements for that day,
and certainly for that meter.
Been there.
Done that.
