1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
frez [133]
2 years ago
13

Examine the symbols below:

Physics
2 answers:
Vilka [71]2 years ago
7 0

For this case we have that by definition, the switch is a control component that opens or closes a circuit.

It is necessary to emphasize that if the switch is open then the flow of electrons from one point to another is not allowed. Thus, it is said that we are in the presence of an open circuit.

The correct option is symbol A, an open switch is shown graphically in the attached image.

Answer:

Option B

iris [78.8K]2 years ago
6 0

Answer: Symbol A

Explanation:

The four symbols described here represent:

- Symbol A shows two dots and a line draw from one not connected to the other.  --> this is an open switch. A switch is component of a circuit that is used to open/close the circuit in order to interrupt/allow the flow of current through the circuit. In this case, the switch is open, since the line does not connect the second dot.

- Symbol B shows two dots and a line draw from one connected to the other.  --> this is the symbol used to represent the switch when it is closed, so it is a closed switch.

- Symbol C shows vertical lines in the pattern long, short, long, and short with a plus and minus symbol on it. --> this symbol represents a battery, which consists of two or more cells and provides the electromotive force that pushes the electrons along the circuit.

Therefore, the correct symbol representing the open switch is

Symbol A

You might be interested in
What is pulling force? Give any two examples.,
Dima020 [189]

Answer:

Push or Pull Forces - example

When you push against a wall the force that you exert is an example of a push force. When you pull a trolley car the force that you exert is an example of pull force.

8 0
2 years ago
An 18.5-cm-diameter loop of wire is initially oriented perpendicular to a 1.5-T magnetic field. The loop is rotated so that its
nikdorinn [45]

Answer:

The average induced emf in the loop is 0.20 V

Explanation:

Given:

Radius of loop r = \frac{d}{2} = 9.25 \times 10^{-2} m

Magnetic field B = 1.5 T

Change in time \Delta t = 0.20 sec

According to the faraday's law,

Induced emf is given by

    \epsilon = -\frac{\Delta \phi}{\Delta t}

Where \phi = magnetic flux

  \phi = BA\cos0                                ( here \theta = 0 )      

Where A = \pi r^{2}

We neglect minus sign because it's shows lenz law

   \epsilon  = \frac{B \pi r^{2}  }{\Delta t}

   \epsilon = \frac{1.5 \times 3.14 \times (9.25 \times 10^{-2} )^{2} }{0.20}

   \epsilon = 0.20 V

Therefore, the average induced emf in the loop is 0.20 V

4 0
3 years ago
The children at the local park think the slide is too slow. There is too much fiction. What could you do to decrease the amount
igor_vitrenko [27]
In order to decrease the friction on the slide,
we could try some of these:

-- Install a drippy pipe across the top that keeps continuously
dripping olive oil on the top end of the slide.  The oil oozes
down the slide and keeps the whole slide greased.

-- Hire a man to spread a coat of butter on the whole slide,
every 30 minutes.

-- Spray the whole slide with soapy sudsy water, every 30 minutes.

-- Drill a million holes in the slide,and pump high-pressure air
through the holes.  Make the slide like an air hockey table.

-- Keep the slide very cold, and keep spraying it with a fine mist
of water.  The water freezes, and a thin coating of ice stays on
the slide.

-- Ask a local auto mechanic to please, every time he changes
the oil in somebody's car, to keep all the old oil, and once a week
to bring his old oil to the park, to spread on the slide.  If it keeps
the inside of a hot car engine slippery, it should do a great job
keeping a simple park slide slippery.

-- Keep a thousand pairs of teflon pants near the bottom of the ladder
at the beginning of the slide.  Anybody who wants to slide faster can
borrow a set of teflon pants, put them on before he uses the slide, and
return them when he's ready to go home from the park.
7 0
3 years ago
Help please <br> hhjshwjsjejjenrhrhfhhfheisiw
DanielleElmas [232]

Answer:

A

Explanation:

4 0
3 years ago
Suppose a shrimp has been put on the ground that has just been taken out of water.Now touch the shrimp from a distance by a stic
Alex777 [14]

Answer:

yes

Explanation:

I would say yes because it's exerting some type of force as it reacts to the stick to make it jump straight in an upwards direction

4 0
2 years ago
Read 2 more answers
Other questions:
  • Javelin at 72 meters/second. he throws it at an angle of 22 degrees. how fast is he throwing it in the x-direction in meters/sec
    13·1 answer
  • A massless spring with force constant ????=200N/m hangs from the ceiling. A 2.0-kg block is attached to the free end of the spri
    15·1 answer
  • A cannonball is launched with initial velocity of magnitude v0 over a horizontal surface. At what minimum angle
    6·1 answer
  • Which map would be most likely to cause the National Weather Service to issue a weather warning for Florida?
    8·2 answers
  • 1.) What things signal the coming of spring?
    12·1 answer
  • An inventor claims to have developed a resistance heater that supplies 1.2 kWh of energy to a room for each kWh of electricity i
    8·1 answer
  • A 50 g copper calorimeter contains 250 g of water at 20 C. How much steam be condensed into the water to make the final temperat
    14·1 answer
  • SC.912.P.12.10
    12·1 answer
  • Which of the following equations represents an acid base reaction?
    12·2 answers
  • The charge of an electron is 1.6x10^'' C. How many electrons does it take to make 1 C of charge?
    14·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!