Answer:
The fence is 5feet less.
Explanation:
We need to determine
The less amount of fence required, if the enclosure has full width and reduced length, compared to full length and reduced width.
Approach & WorkingArea of lawn = 30 × 403/4th of the area of lawn = ¾(30 × 40) = 30 * 30
When full width will be fenced, and reduced length will be fenced.
Width = 30 feet30 * L = 30 * 30Hence, length = 30 feetLength of fence needed = 2(30 + 30) = 120 feet
When full length will be fenced, and reduced width will be fenced
Length = 40 feet40 * W = 30 * 30W = 22.5 feetLength of fence needed = 2(40 + 22.5) = 125 feet
Difference in length of fence needed = 125 – 120 = 5 feet.
Answer:
Vector quantities are important in the study of motion. Some examples of vector quantities include force, velocity, acceleration, displacement, and momentum. The difference between a scalar and vector is that a vector quantity has a direction and a magnitude, while a scalar has only a magnitude. Vector, in physics, a quantity that has both magnitude and direction. It is typically represented by an arrow whose direction is the same as that of the quantity and whose length is proportional to the quantity's magnitude. A quantity which does not depend on direction is called a scalar quantity. Vector quantities have two characteristics, a magnitude and a direction. The resulting motion of the aircraft in terms of displacement, velocity, and acceleration are also vector quantities. A vector quantity is different to a scalar quantity because a quantity that has magnitude but no particular direction is described as scalar. A quantity that has magnitude and acts in a particular direction is described as vector.
Explanation:
Hi is together and immediately after the collision are
Answer:
Circuit A is a series circuit
The total resistance in Circuit A is greater than that in Circuit B
Explanation:
The missing diagram is here attached. For circuit A, considering that in a series circuit, the current through each load is the same and the total voltage across the circuit is the sum of the voltages across each load. Moreover, current flowing through each resistor in a parallel circuit is different, depending on the resistance. Therefore, we can say that when resistors are connected in parallel, more current flows from the source than flow for any of them individually, so the total resistance is lower.