All categories

3 years ago

DRIVERS ED

Engineering

1 answer:

Paladinen [302]3 years ago

3 0

Answer:

You need to start slowing down, it's dangerous and illegal to drive around or under an active crossing gate.

Explanation:

No matter what even if u are impatient when those lights start flashing u need to just immediately stop and just wait for it to pass. that's how many crashed have happen cause people want to play "let's race the train and see if i can make it". just because the train looks slow and looks as if it isn't moving that fast it's going atleast 190-200 mph if it's a high speed and no matter what u cant escape it. We want u home in one piece, just wait !!

You might be interested in

Determine the dimensions for W if W = P L^3 / (M V^2) where P is a pressure, L is a length, M is a mass, and V is a velocity.

Eva8 [605]

Correct answer is option E. No dimensions

As we know formula Pressure (P) is $\frac{F}{A}$

also,

Dimensional formula of Pressure is $M^{1}L^{-1}T^{-2}$
Dimensional formula of length is L
Dimensional formula of mass is M
Dimensional formula of velocity is $L^{1} T^{-1}$

So, as given W= $\frac{P*L^{3} }{M*V^{2} }$

Dimensional formula of W = $\frac{M^{1}L^{-1}T^{-2} L^{3} }{M^{1} L^{2}T^{-2} }$

since all terms get cancelled

Work is dimensionless i.e no dimensions

Learn more about dimensions here brainly.com/question/20351712

#SPJ10

6 0

2 years ago

An insulated rigid tank is divided into two compartments of different volumes. Initially, each compartment contains the same ide

storchak [24]

Answer:

Explanation:

Given that

Mass of 1 = $m_1$

Mass of 2 = $m_2$

Temperature in 1 = $T_1$

Temperature in 2 = $T_2$

Pressure remains i the group apartment

The closed system and energy balance is

$E_{in}-E_{out}=\Delta E_{system}$

The kinetic energy and potential energy are negligible

since it is insulated tank ,there wont be eat transfer from the system

And there is no work involved

$\Delta U = 0$

Let the final temperature be final temperature

$m_1+c_v(T_3-T_1)+m_2c_v(T_3+T_2)=0\\\\m_1+c_v(T_3-T_1)=m_2c_v(T_2-T_3)---(i)$

Using mass balance

$m_3+m_2+m_1$

from eqn i

$m_1+c_v(T_3-T_1)=m_2c_v(T_2-T_3)m_1T_3-m_1T_1=m_2T_2-m_2T_3\\\\m_1T_3+m_2T_3=m_2T_2+m_1T_1\\\\(m_1+m_2)T_3=m_1T_1+m_2T_2\\\\(m_1)T_3=m_1T_1+m_2T_2\\\\T_3=\frac{m_1T_1_m_2T_2}{m_3}$

Therefore the final temperature can be express as

$\large \boxed {T_3=\frac{m_1}{m_3} T_1+\frac{m_2}{m_3}T_2 }$

8 0

3 years ago

You are driving on a roadway with multiple lanes of travel in the same direction, and are approaching an emergency vehicle parke

solmaris [256]

Answer: a. Leave the lane closest to the emergency as soon as it is safe to do so, or slow down to a speed of 20 MPH below the posted speed limit.

Explanation:

Giving a way to the law enforcement vehicle and a medical emergency vehicle is necessary. If one approaches an emergency vehicle parked along the roadway one should change the lane as the vehicle may not move and the driver may also waste his or her time also one should also slow down his or her speed while approaching the vehicle as most of the emergency vehicle are in rush to reach the hospital so the driver should maintain some distance with the medical emergency vehicle.

7 0

3 years ago

A 220-V electric heater has two heating coils that can be switched such that either coil can be used independently or the two ca

Nana76 [90]

Answer:

The resistances of both coils are 131.7 Ω and 29.64 Ω.

Explanation:

Since, there are two coils, they can be used independently or in series or parallel. The power is given as:

Power = P = VI

but, from Ohm's Law:

V = IR

I = V/R

therefore,

P = V²/R

R = V²/P

Hence, the resistance (R) and (P) are inversely proportional. Therefore, the maximum value of resistance will give minimum power, that is, 300 W. And the maximum resistance will be in series arrangement, as in series the total resistance gets higher than, any individual resistance.

Therefore,

Rmax = V²/Pmin = R1 + R2

R1 + R2 = (220 V)²/300 W

R1 + R2 = 161.333 Ω ______ en (1)

Similarly, the minimum resistance will give maximum power. And the minimum resistance will occur in parallel combination. Because equivalent resistance of parallel combination is less than any individual resistance.

Therefore,

(R1 R2)/(R1 + R2) = (220 V)²/2000 W

using eqn (1), we get:

(R1 R2) / 161.333 Ω = 24.2 Ω

R1 R2 = 3904.266 Ω²

R1 = 3904.266 Ω²/R2 _____ eqn (2)

Using this value of R1 in eqn (1), we get:

3904.266/R2 +R2 = 161.333

(R2)² - 161.333 R2 +3904.266 = 0

Solving this quadratic eqn we get two values of R2 as:

R2 = 131.7 Ω OR R2 = 29.64 Ω

when ,we substitute these values in eqn (1) to find R1, we get get the same two values as R2, alternatively. This means that the two coils have these resistance, and the order does not matter.

Therefore, the resistance of both coils are found to be 131.7 Ω and 29.64 Ω

7 0

3 years ago

Some designers suggest that speech recognition should be used in a telephone menu system. This would allow users to interact wit

Ghella [55]

The designers suggest that speech recognition allows for spoken interaction or conversation and spoken prompts or commands.

Explanation:

The speech recognition is used when the user has physical impairments and hands are busy, eyes are occupied and the user cannot read.

We can save time with the usage of speech recognition system. The users are knowledgeable based on the actions available.

The problems faced in speech recognition system are in the noisy environment it has bad microphones and the commands should be learned and remembered.

The other obstacle is error correction is time consuming. the speech production has slow space to speech output provides privacy in public spaces. The disadvantage is it contains large amount of information.

5 0

4 years ago