It depends on the process.
Like for example if the process is isothermal(temperature is constant), you can use,
PV = constant or P1V1 = P2V2 where P1V1 are initial conditions and P2V2 are final.
For adiabatic process,
PV^gamma = constant or P1V1 ^gamma = P2V2 ^gamma.
where gamma = Cp
------
Cv
Cp = specific heat at constant pressure and Cv = specific at constant volume.
Value of Gamma will be given in question.
Hope this helps!
Lead.
Lead paint was a big problem and now lead has been removed from paint because it was found to be dangerous to the health of living organisms.
Hope this helps! :)
Answer:
Nucleus
Explanation: it is the center of the atom, and contains protons and nuetrons
<h3><u>Answer</u>;</h3>
= 226 Liters of oxygen
<h3><u>Explanation</u>;</h3>
We use the equation;
LiClO4 (s) → 2O2 (g) + LiCl, to get the moles of oxygen;
Moles of LiClO4;
(500 g LiClO4) / (106.3916 g LiClO4/mol)
= 4.6996 moles
Moles of oxygen;
But, for every 1 mol LiClO4, two moles of O2 are produced;
= 9.3992 moles of Oxygen
V = nRT / P
= (9.3992 mol) x (8.3144621 L kPa/K mol) x (21 + 273) K / (101.5 kPa)
= 226 L of oxygen
Answer : The molar mass of solute is, 89.9 g/mol
Explanation : Given,
Mass of solute = 5.8 g
Mass of solvent (water) = 100 g
Formula used :
where,
= change in freezing point
= temperature of pure solvent (water) = 
= temperature of solution = 
= freezing point constant of water = 
m = molality
Now put all the given values in this formula, we get
Therefore, the molar mass of solute is, 89.9 g/mol
