3 years ago

Pouring molten aluminum into a mold and allowing it to cool forms?

1 answer:

7 0

Answer:it forms a molten mold that makes it hard to be able to smash something into it then make something like a key

Explanation:

You might be interested in

Implement the following Matlab code:

vagabundo [1.1K]

28384 *x soít cos estematema

3 0

3 years ago

1. Design a circuit, utilizing set/reset coils where PB 1 starts Motor 1 and PB2 stops Motor 1. Pressing and releasing either pu

lianna [129]

Answer:

Circuit attached with explanation

Explanation:

Hi Dear,

A circuit is attached for your reference.

When you press "start" PB, the supply reaches the motor starter relay coil "M" that is also in parallel with the "start" PB which allows the motor to remain ON even when you release "start" PB as supply to relay coil is directly from supply "L" through "M".

To stop motor just press "stop" PB and the circuit breaks which de-energize the relay coil and the motor stops.

Hope this finds easy to you.

5 0

3 years ago

Why do we need technical sketching?

Scrat [10]

Technical Drawings give a better understanding of what is needed and required in the project.

Explanation:

8 0

3 years ago

Read 2 more answers

What makes building an airplane while flying so difficult?

Naddik [55]

Answer: Because if something goes wrong while you are flying it it will crash

Explanation:

7 0

3 years ago

What happen to the clutch system when you step-on and releasing the clutch pedal?

soldi70 [24.7K]

Answer:

Step On: Your foot forces the clutch pedal down and then causes it to take up the slack. This, in turn, causes the clutch friction disk to slip, creating heat and ultimately wearing your clutch out.

Step Off: When the clutch pedal is released, the springs of the pressure plate push the slave cylinder's pushrod back, which forces the hydraulic fluid back into the master cylinder.

7 0

3 years ago