when approaching the front of an idling jet engine, the hazard area extends forward of the engine approximately 25 feet.
<h3>What impact, if any, would jet fuel and aviation gasoline have on a turbine engine?</h3>
Tetraethyl lead, which is present in gasoline, deposits itself on the turbine blades. Because jet fuel has a higher viscosity than aviation gasoline, it may retain impurities with greater ease.
Once the gasoline charge has been cleared, start the engine manually or with an electric starter while cutting the ignition and using the maximum throttle.
On the final approach, the aeroplane needs to be re-trimmed to account for the altered aerodynamic forces. A substantial nose-down tendency results from the airflow producing less lift on the wings and less downward force on the horizontal stabiliser due to the reduced power and slower velocity.
Learn more about turbine engine refer
brainly.com/question/807662
#SPJ4
Answer:
The ladder is 3.014 m tall.
Explanation:
To solve this problem, we must use the following formula:
v = x/t
where v represents the woman’s velocity, x represents the distance she climbed (the height of the ladder), and t represents the time it took her to move this distance
If we plug in the values we are given for the problem, we get:
v = x/t
2.20 = x/1.37
To solve this equation for x (the height of the ladder), we must multiply both sides by 1.37. If we do this, we get:
x = (2.20 * 1.37)
x = 3.014 m
Therefore, the ladder is 3.014 m tall.
Hope this helps!
The linear speed of the pepperoni is 0.628 m/s. Its direction is tangential to the circle.
We know that;
v = rω
r = radius of the piece = 10 cm or 0.1 m
ω = angular velocity
We have to convert 60 revolutions per minute to radians per second
1 rev/min = 0.10472 rad/s
60 revolutions per minute = 60 rev/min × 0.10472 rad/s/1 rev/min
= 6.28 rad/s
v = 0.1 m × 6.28 rad/s
v = 0.628 m/s
The direction of this velocity is tangential to the circle.
Learn more: brainly.com/question/4612545
Explanation:
Question 1
1.The wires are made of conducting materials e.g copper
2. A light bulb is made of filament material e.g tungsten with gases enclosed in a glass material
3.The lens is made of transparent glass material
4 The reflector is made of plastic with silver lining
5. The exterior casing of most flash lights are made of plastic
Question 2.
1.Copper is used to conduct electric current from the battery to the bulb
2.The tungsten filament ignite the gases and causes it to glow
3. The lens covers the lamp on your flashlight so that the glass on the lamp
/bulbs does not get broken.
4.The reflector redirects the light rays from the lamp, creating a steady beam of light, which is the light you see emitting from the flashlight.
5. The exterior cases houses the entire assembly and makes the flash light handy for use
