Answer:
False
Explanation:
According to the American National Standard for Engineering Drawings, there are ten (10) different types of lines used in engineering drawings to communicate important information about the item. Some of these lines could either be thick or thin. These include the following:
1. Visible Line
2. Hidden Line
3. Section Line
4. Center Line And Symmetry Line
5. Dimension Line Extension Line And Leader
6. Cutting-Plane Line Or Viewing-Plane Line
7. Break Line
8. Phantom Line
9. Stitch Line
10. Chain Line
Answer:
) You must create a Low Pass Filter for an audio amplifier. You must pass 10khz and block
60khz. In designing this, you must choose a cutoff frequency exactly half way between
these two frequencies. In addition, you must use a 0.2uF capacitor in you LPF circuit.
Given these criteria, analyze this circuit, and determine the necessary resistor value in
Ohms. Find the output Voltage at both ends of the spectrum. Based on your results, is
this a good design? NOTE: You MUST show your work (when using MS Word, choose
“Insert”--- “Equation”). (6 marks)
a. Solve for fc
b. Solve for R
c. Solve for Vout at 10khz
d. Solve for Vout at 60khz
e. Good design> (yes or no with an explanation)
Explanation:
Answer:
That there is a grounded winding
Explanation:
When the ohm meter is set to the maximum range, and a meter lead is placed on the compressor casing. A reading of any value on the ohm meter is an indication that the winding is grounded in which case it would be necessary to change the compressor
The compressor terminals are covered with a shroud making it difficult to take measurements. To make it easier, the plug can extended with an extension wire.
Sorry my drawings aren’t great, but I hope this helps