Answer:
hazardous chemicals leaving the workplace is labeled, tagged or marked with the following information: product identifier; signal word; hazard statement
Explanation:
this is so you know what chemicals are in it
The coil polarity in a waste-spark system is determined by the direction in which the coil is wound (left-hand rule for conventional current flow)and can’t be changed. For example, if a V-8 engine has a firing order of 18436572 and the number 1 cylinder is on compression, which cylinder will be on the exhaust stroke?
Answer:
launch- The first stage is ignited at launch and burns through the powered ascent until its propellants are exhausted. The first stage engine is then extinguished, the second stage separates from the first stage, and the second stage engine is ignited. The payload is carried atop the second stage into orbit
powered ascent-The first stage is ignited at launch and burns through the powered ascent until its propellants are exhausted. The first stage engine is then extinguished, the second stage separates from the first stage, and the second stage engine is ignited. The payload is carried atop the second stage into orbit
coasting flight-
When the rocket runs out of fuel, it enters a coasting flight. The vehicle slows down under the action of the weight and drag since there is no longer any thrust present. The rocket eventually reaches some maximum altitude which you can measure using some simple length and angle measurements and trigonometry.
ejection charge-At the end of the delay charge, an ejection charge is ignited which pressurizes the body tube, blows the nose cap off, and deploys the parachute. The rocket then begins a slow descent under parachute to a recovery. The forces at work here are the weight of the vehicle and the drag of the parachute.
slow decent- slow downs (i guess)
recovery-A recovery period is typically characterized by abnormally high levels of growth in real gross domestic product, employment, corporate profits, and other indicators. This is a turning point from contraction to expansion and often results in an increase in consumer confidence
Explanation:
Answer:
Sealing agent
Explanation:
Generally, when we have water leaks in almost any building or equipment, we use a sealant. However, this sealant could be of different types depending on the peculiarity of the leakage.
Thus, the correct answer is sealing agent.
Answer:
1561.84 MPa
Explanation:
L=20 cm
d1=0.21 cm
d2=0.25 cm
F=5500 N
a) σ= F/A1= 5000/(π/4×(0.0025)^2)= 1018.5916 MPa
lateral strain= Δd/d1= (0.0021-0.0025)/0.0025= -0.16
longitudinal strain (ε_l)= -lateral strain/ν = -(-0.16)/0.3
(assuming a poisson's ration of 0.3)
ε_l =0.16/0.3 = 0.5333
b) σ_true= σ(1+ ε_l)= 1018.5916( 1+0.5333)
σ_true = 1561.84 MPa
ε_true = ln( 1+ε_l)= ln(1+0.5333)
ε_true= 0.4274222
The engineering stress on the rod when it is loaded with a 5500 N weight is 1561.84 MPa.
