To prove that they were tested to see if they were correct or not.
I think:/
Wet chemical system components typically are a storage tank or tanks, piping, nozzles, and an actuating mechanism.
<h3>
Which parts make up an actuation mechanism?</h3>
The typical components of an actuation mechanism include a motor, transmission, control units, feedback, signaling, interlocking, and shutdown units. An electrical, hydraulic, or pneumatic drive is used to move a valve, shutter, or gate, which acts as an actuator to regulate the flow of fluids or gases.
<h3>
What is the operation of the operator-dependent actuating mechanism?</h3>
When an automatic clutch is engaged, the control system 2 replaces the target-value signals coming over feeders 1 with the operator force signal if the operator uses the operator-dependent actuating mechanism.
Learn more about automatic clutch here:-
brainly.com/question/8012302
#SPJ4
Answer:
- <u>25.0 liter of nitrogen gas</u>
Explanation:
<u>1. Chemical equation</u>
Ammonium nitrite is a solid compound that decomposes into nitrogen gas and water vapor as per this chemical equation:
<u>2. Mole ratio</u>
<u>3. Volume ratio</u>
Since, both species are gases and are at same temperature and pressure, the volume ratio is equal to the mol ratio.
Thus, the volume ratio is:
<u>4. Use the volume ratio with the known amount of water produced</u>
a. Hydrogen
Hydrogen has a line at 410 nm.
Mercury has a line at 405 nm.
Sodium and neon have no lines near 412 nm.
Solutions are a type of mixture.
A solution is a homogeneous mixture of particles so small that they cannot be seen and cannot be filtered out.
Definition: Homogeneous mixture looks the same.
I grabbed these from my science notes, hope this helps.
