Answer:
A lot, because it belt inclined at an angle of 36.9° above the horizontal.
I need points haha!
Explanation:
According to the Henderson-Hasselbalch equation, the relation between pH and
is as follows.
pH = 
where, pH = 7.4 and
= 7.21
As here, we can use the
nearest to the desired pH.
So, 7.4 = 7.21 + 
0.19 = 
= 1.55
1 mM phosphate buffer means
+
= 1 mM
Therefore, the two equations will be as follows.
= 1.55 ............. (1)
+
= 1 mM ........... (2)
Now, putting the value of
from equation (1) into equation (2) as follows.
1.55
= 1 mM
2.55
= 1 mM
= 0.392 mM
Putting the value of
in equation (1) we get the following.
0.392 mM +
= 1 mM
= (1 - 0.392) mM
= 0.608 mM
Thus, we can conclude that concentration of the acid must be 0.608 mM.
Answer:
D. I've watched Jurassic park uwu
The term "valence electrons" refers to all of the electrons in an atom's outermost shell.
The centre of the atom is where the nucleus is. The nucleus contains protons and neutrons. The electrons travel in a specific circular direction and at a specific distance from the nucleus.
The atom's final shell's electrons take part in chemical reactions and the production of bonds. Both ionic and covalent bonding involve valence electrons. Metals are elements with one, two, or three electrons in their final shell.
These substances become positive ions after losing their electrons. Non-metals are substances with 5, 6, or 7 electrons in the outermost shell. These substances all gain electrons and change into negative ions.
Ionic bonds are those created by the transfer of electrons between metals and non-metals. For instance, ionic bonding allows sodium and chlorine to interact to generate sodium chloride.
To know more about valence electrons here
brainly.com/question/371590
#SPJ4
Answer:

Explanation:
Hello,
In this case the undergoing chemical reaction is shown on the attached picture whereas cyclohexanol is converted into cyclohexene and water by the dehydrating effect of the sulfuric acid. Thus, for the starting 3 mL of cyclohexanol, the following stoichiometric proportional factor is applied in order to find the theoretical yield of cyclohexene in moles:

Besides, the mass could be computed as well by using the molar mass of cyclohexene:

Even thought, the volume could be also computed by using its density:

Best regards.