Answer:
enable the used ports in the router with their respective IP address and only the connected ports in the switch. Allow configure the STP on the switch
Explanation:
Network switches are used to connect a group of computer devices in a network LAN. It is automatically enabled when a port is connected and creates a MAC address table of the computers connected to it. STP or spanning-tree protocol is a protocol used to prevent looping in a switch. Unused ports can be disabled for security reasons.
A router is a network device that is used to forward packets between networks. All used ports in a router must be enabled and configured with an IP address and subnet mask.
Answer: 32 bit number
Explanation:
The IP address basically contain 32 bit number as due to the growth of the various internet application and depletion of the IPV4 address. The IP address basically provide two main function is that:
- The location addressing
- The network interface identification
The IP address are basically available in the human readable format. The IPV6 is the new version of the IP address and its uses 128 bits.
Answer:
welp you have to umm look up Microsoft and you habe to reset the rask
Answer:
yes i agree with that the answer is in fact true
Explanation:
follow my in sta gram at grac.ehihi