Answer:
<h3>
<em>2</em><em>4</em><em>7</em><em>9</em><em> </em><em>Newton</em></h3>
<em>Sol</em><em>ution</em><em>,</em>
<em>Mass</em><em>=</em><em>1</em><em>0</em><em>0</em><em> </em><em>kg</em>
<em>Accele</em><em>ration</em><em> </em><em>due</em><em> </em><em>to</em><em> </em><em>gravity</em><em>(</em><em>g</em><em>)</em><em>=</em><em>2</em><em>4</em><em>.</em><em>7</em><em>9</em><em> </em><em>m</em><em>/</em><em>s^</em><em>2</em>
<em>Now</em><em>,</em><em>.</em>
<em></em>
<em>hope</em><em> </em><em>this</em><em> </em><em>helps</em><em> </em><em>.</em><em>.</em>
<em>Good</em><em> </em><em>luck</em><em> on</em><em> your</em><em> assignment</em><em>.</em><em>.</em>
Answer:
In a velocity selector, there are two forces namely;
» Electric field Intensity
» Magnetic field density
<u>Relationship</u><u>:</u>
E is the electric field intensity
B is the magnetic flux density
Because: Some of the work done by the machine is used to overcome the friction created by the use of the machine. ... Work output can never be greater than work input. Machines allow force to be applied over a greater distance, which means that less force will be needed for the same amount of work.
E = I R
That means
Voltage = (current) x (resistance)
= (2.5 A) x (2.4 ohms)
= 6 volts .
Refer to the figure below.
R = resistance.
Case 1:
The voltage source is V₁ and the current is 10 mA. Therefore
V₁ = (10 mA)R
Case 2:
The voltage source is V₂ and the current is 8 mA. Therefore
V₂ = (8 mA)R
Case 3:
The voltage across the resistance is V₁ - V₂. Therefore the current I is given by
V₁ - V₂ = IR
10R - 8R = (I mA)R
2 = I
The current is 2 mA.
Answer: 2 mA