Answer:
The amount of work the factory worker must to stop the rolling ramp is 294 joules
Explanation:
The object rolling down the frictionless ramp has the following parameters;
The mass of the object = 10 kg
The height from which the object is rolled = 3 meters
The work done by the factory worker to stop the rolling ramp = The initial potential energy, P.E., of the ramp
Where;
The potential energy P.E. = m × g × h
m = The mass of the ramp = 10 kg
g = The acceleration due to gravity = 9.8 m/s²
h = The height from which the object rolls down = 3 m
Therefore, we have;
P.E. = 10 kg × 9.8 m/s² × 3 m = 294 Joules
The work done by the factory worker to stop the rolling ramp = P.E. = 294 joules
Answer:
1.) Micrometres screw gauge
2.) Tape rule.
Explanation:
Given that the diameter and the length of a thin wire, approximately 1m in length, are measured as accurately as possible.
what are the best instruments to use ?
To measure the diameter of a thin wire, the best instrument to use is known as micrometres screw gauge.
And to measure the length of a thin wire up to 1 m, the measuring device can be tape rule or long metre rule.
Answer:
SI derived units
Other quantities, called derived quantities, are defined in terms of the seven base quantities via a system of quantity equations. The SI derived units for these derived quantities are obtained from these equations and the seven SI base units.
Explanation:
Hope this helps :D
Answer:
i'm good, hru hope ur staying safe
Explanation:
The answer would be solubility
